Paper · 2015 · Open access

Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell

Abbas Belfar, Benameur Amiri, Hocine Ait-Kaci

Electronic Sumy State University Institutional Repository (Sumy State University), 7(2), 02007-1–02007-7 · Published 1 June 2015

Read the free full textCite this paper

In brief

“Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell” is a 2015 paper by Abbas Belfar and 2 co-authors, published in Electronic Sumy State University Institutional Repository (Sumy State University). OpenAlex counts 6 citations as of 16 November 2026. It is open access: the full text is free to read at Electronic Sumy State University Institutional Repository (Sumy State University).

Citations
6
Most cited in
2017 (1)
Field-weighted impact
0.14
Authors
3

Abstract

By using an electrical-optical AMPS-1D program (One Dimensional Analysis of Microelectronic and Photonic structures), a n-i-p type solar cell, based on hydrogenated amorphous silicon (a-Si : H) and hydrogenated nanocrystalline silicon oxide (nc-SiOx : H) has been investigated and simulated. The numerical analysis describes the modeling of the external cell performances, like, the short-circuit current (JSC), the open circuit voltage (VOC), the fill factor (FF) and efficiency (Eff) with the oxygen content in the p-nc-SiOx : H window layer by varying its mobility band gap (Eg) associated simultaneously to the effect of the absorber layer (i-a-Si : H) thickness. Also, the i-a-Si : H absorber layer band gap was optimized. The simulation result shows that the VOC depend strongly on the band offset (ΔEV) in valence band of p-side. But, VOC does not depend on the thickness of the intrinsic layer. However, VOC increases when the energy band gap of the intrinsic layer is higher. It is demonstrated that the highest efficiency of 10.44 % (JSC = 11.67 mA/cm2; FF = 0.829; VOC = 1070 mV) has been obtained when values of p-nc-SiOx : H window layer band gap, i-a-Si : H absorber layer band gap and i-a-Si : H absorber layer thickness are 2.10 eV, 1.86 eV, and 550 nm, respectively.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Belfar, A., Amiri, B., & Ait-Kaci, H. (2015). Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell. Electronic Sumy State University Institutional Repository (Sumy State University), 7(2), 02007-1–02007-7. http://essuir.sumdu.edu.ua/handle/123456789/41380

MLA 9

Belfar, Abbas, et al. “Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell.” Electronic Sumy State University Institutional Repository (Sumy State University), vol. 7, no. 2, 2015, pp. 02007-1–02007-7. http://essuir.sumdu.edu.ua/handle/123456789/41380.

Chicago

Belfar, Abbas, Benameur Amiri, and Hocine Ait-Kaci. 2015. “Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell.” Electronic Sumy State University Institutional Repository (Sumy State University) 7 (2): 02007-1–02007-7. http://essuir.sumdu.edu.ua/handle/123456789/41380.

Harvard

Belfar, A., Amiri, B. and Ait-Kaci, H. (2015) ‘Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell’, Electronic Sumy State University Institutional Repository (Sumy State University), 7(2), pp. 02007-1–02007-7. Available at: http://essuir.sumdu.edu.ua/handle/123456789/41380.

IEEE

A. Belfar, B. Amiri, and H. Ait-Kaci, “Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell,” Electronic Sumy State University Institutional Repository (Sumy State University), vol. 7, no. 2, pp. 02007-1–02007-7, 2015.

BibTeX

@article{belfar2015optimization,
  title     = {{Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell}},
  author    = {Belfar, Abbas and Amiri, Benameur and Ait-Kaci, Hocine},
  journal   = {Electronic Sumy State University Institutional Repository (Sumy State University)},
  year      = {2015},
  volume    = {7},
  number    = {2},
  pages     = {02007-1--02007-7},
  url       = {http://essuir.sumdu.edu.ua/handle/123456789/41380}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
201711
201911
202011
202111
202311
202411

Its field-weighted citation impact is 0.14: it has been cited 0.14 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon and Solar Cell Technologies

  • hydrogenated amorphous silicon
  • bandgap optimization
  • absorber thickness
  • open-circuit voltage
  • short-circuit current
  • fill factor
  • solar cell efficiency
  • band offset

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Belfar, A., Amiri, B., & Ait-Kaci, H. (2015). Optimization of Band Gap and Thickness for the Development of Efficient n-i-p+ Solar Cell. Electronic Sumy State University Institutional Repository (Sumy State University), 7(2), 02007-1–02007-7. http://essuir.sumdu.edu.ua/handle/123456789/41380

How many times has this paper been cited?

6 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at Electronic Sumy State University Institutional Repository (Sumy State University).

Who wrote this paper?

Abbas Belfar, Benameur Amiri, Hocine Ait-Kaci.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.