Journal article · 2024 · Open access

The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells

Tayeb Youcef Belabbas, Abbas Belfar

Physica Scripta, 99(11), 115544 · Published 14 October 2024 · DOI 10.1088/1402-4896/ad8686

Free PDFView at the publisherCite this paper

In brief

“The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells” is a 2024 journal article by Tayeb Youcef Belabbas and Abbas Belfar, published in Physica Scripta. OpenAlex counts 4 citations as of 16 November 2026. It is open access: the full text is free to read at Physica Scripta.

Citations
4
Most cited in
2026 (3)
Field-weighted impact
0.38
References
68
Authors
2

Abstract

This study focuses on a p-i-n single junction solar cell made of hydrogenated amorphous silicon oxide (a-SiOx:H), aiming to enhance solar cell efficiency by mitigating the impact of discontinuities and mismatches occurring at the i/p defect-rich interface between the window layer and the absorber layer. To address this concern, the impact of adding a thin i-a-SiOx:H buffer layer between the p-a-SiOx:H window layer and the i-a-SiOx:H active layer was investigated through numerical modeling using the AMPS-1D (Analysis of Micro-electronic and Photonic Structures) computer program. Implementing these changes led to a remarkable increase in conversion efficiency, rising from 5.714% to an impressive 8.929%. The increase in short-circuit current (JSC), however, is due to improved quantum efficiency at short wavelengths between 350 and 550 nm. Furthermore, enhancing the built-in potential (Vbi) at the i/p interface, combined with the buffer layer’s appropriate band gap energy, increases VOC (open-circuit voltage) from 850 to 993 mV. The substantial improvement in the fill factor (FF) from 63.1 to 83.1% can be largely attributed to the smoothed band offset, primarily facilitated by the presence of the buffer layer at the p/i interface, which led to more efficient extraction of photogenerated holes. To ensure effective usage of the buffer layer, the thickness of a-SiOx:H (buffer layer) varied between 3 nm and 9 nm, while the p-type doping concentration of the same layer was adjusted between 0 and 1020 cm−3. In summary, adding a 3 nm thick a-SiOx:H buffer layer with an intermediate band gap and with a p-type doping concentration (NA) below 1018 cm−3 at the i/p interface improves the electrical and optical properties of the p-i-n solar cells (EFF = 8.951%; VOC = 0.994 V; FF = 83.1%; JSC = 10.842 mA.cm−2).

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Belabbas, T. Y., & Belfar, A. (2024). The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells. Physica Scripta, 99(11), 115544. https://doi.org/10.1088/1402-4896/ad8686

MLA 9

Belabbas, Tayeb Youcef, and Abbas Belfar. “The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells.” Physica Scripta, vol. 99, no. 11, 2024, p. 115544. https://doi.org/10.1088/1402-4896/ad8686.

Chicago

Belabbas, Tayeb Youcef and Abbas Belfar. 2024. “The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells.” Physica Scripta 99 (11): 115544. https://doi.org/10.1088/1402-4896/ad8686.

Harvard

Belabbas, T. Y. and Belfar, A. (2024) ‘The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells’, Physica Scripta, 99(11), p. 115544. doi:10.1088/1402-4896/ad8686.

IEEE

T. Y. Belabbas and A. Belfar, “The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells,” Physica Scripta, vol. 99, no. 11, p. 115544, 2024, doi: 10.1088/1402-4896/ad8686.

BibTeX

@article{belabbas2024advantages,
  title     = {{The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells}},
  author    = {Belabbas, Tayeb Youcef and Belfar, Abbas},
  journal   = {Physica Scripta},
  year      = {2024},
  volume    = {99},
  number    = {11},
  pages     = {115544},
  doi       = {10.1088/1402-4896/ad8686},
  url       = {https://doi.org/10.1088/1402-4896/ad8686}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon and Solar Cell Technologies

  • hydrogenated amorphous silicon oxide
  • buffer layer
  • p-i-n solar cells
  • single-junction solar cells
  • interface discontinuity
  • band offset
  • conversion efficiency
  • open-circuit voltage

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Belabbas, T. Y., & Belfar, A. (2024). The advantages of employing i-a-SiOX:H as a buffer layer in hydrogenated amorphous silicon oxide solar cells. Physica Scripta, 99(11), 115544. https://doi.org/10.1088/1402-4896/ad8686

How many times has this paper been cited?

4 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at Physica Scripta.

Who wrote this paper?

Tayeb Youcef Belabbas, Abbas Belfar.

What is the DOI of this paper?

10.1088/1402-4896/ad8686. The permanent link is https://doi.org/10.1088/1402-4896/ad8686.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.