Journal article · 1997 · Open access

Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses

F. Nishimura, N. Watanabe, Kikuaki Tanaka

Journal de Physique IV (Proceedings), 07(C5), C5-441–C5-446 · Published 1 November 1997 · DOI 10.1051/jp4:1997570

Open PDFView at the publisherCite this paper

In brief

“Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses” is a 1997 journal article by F. Nishimura and 2 co-authors, published in Journal de Physique IV (Proceedings). OpenAlex counts 1 citations as of 22 November 2026. It is open access: the full text is free to read at Journal de Physique IV (Proceedings).

Citations
1
Most cited in
2023 (1)
References
13
Authors
3

Abstract

The uniaxial thermomechanical behavior of a polycrystalline Fe-9%Cr-5%Ni-14%Mn-6%Si (all wt.%) shape memory alloy is investigated for both tensile and compressive stress states.The martensite start stresses measured upon tension and compression loading of austenite depend linearly on temperature, thus forming straight lines in the stress-temperature regime.The lines belonging to tension and compression are not symmetric with respect to zero stress.The austenite start and finish temperatures measured upon heating under external stress, on samples which had previously been strained by inducing martensite, vary linearly with the stress level applied, thus forming the so-called austenite start and finish lines.The temperature difference (retransfornation range) between the austenite start and finish lines increases with increasing amount of previously induced straidmartensite, but the slopes of these lines remain the same.At the minimum amount of previously induced straidmartensite the start and finish lines coincide and are called initial austenite lines.The austenite start and finish lines obtained after previous tensile straining extend to the compression side without change of slope, while the austenite lines obtained after previous compression straining extend to the tensile side without change of slope.The determined tiansformation lines provide a good means to explain the thermomechanical response of the alloy, i.e., the stress-strain-temperature hysteresis loops.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Nishimura, F., Watanabe, N., & Tanaka, K. (1997). Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses. Journal de Physique IV (Proceedings), 07(C5), C5-441–C5-446. https://doi.org/10.1051/jp4:1997570

MLA 9

Nishimura, F., et al. “Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses.” Journal de Physique IV (Proceedings), vol. 07, no. C5, 1997, pp. C5-441–C5-446. https://doi.org/10.1051/jp4:1997570.

Chicago

Nishimura, F., N. Watanabe, and Kikuaki Tanaka. 1997. “Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses.” Journal de Physique IV (Proceedings) 07 (C5): C5-441–C5-446. https://doi.org/10.1051/jp4:1997570.

Harvard

Nishimura, F., Watanabe, N. and Tanaka, K. (1997) ‘Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses’, Journal de Physique IV (Proceedings), 07(C5), pp. C5-441–C5-446. doi:10.1051/jp4:1997570.

IEEE

F. Nishimura, N. Watanabe, and K. Tanaka, “Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses,” Journal de Physique IV (Proceedings), vol. 07, no. C5, pp. C5-441–C5-446, 1997, doi: 10.1051/jp4:1997570.

BibTeX

@article{nishimura1997uniaxial,
  title     = {{Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses}},
  author    = {Nishimura, F. and Watanabe, N. and Tanaka, Kikuaki},
  journal   = {Journal de Physique IV (Proceedings)},
  year      = {1997},
  volume    = {07},
  number    = {C5},
  pages     = {C5-441--C5-446},
  doi       = {10.1051/jp4:1997570},
  url       = {https://doi.org/10.1051/jp4:1997570}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Materials Science › Materials Chemistry › Shape Memory Alloy Transformations

  • Fe-based shape memory alloy
  • martensitic transformation
  • stress-induced martensite
  • uniaxial tension and compression
  • polycrystalline alloys

Work with this paper

Most-cited papers in Materials Science

All highly cited Materials Science papers

Questions about this paper

How do I cite this paper in APA style?

Nishimura, F., Watanabe, N., & Tanaka, K. (1997). Uniaxial Transformation Behavior in Tension and Compression in an Fe-Based Shape Memory Alloy : Transformation Lines and Thermomechanical Hystereses. Journal de Physique IV (Proceedings), 07(C5), C5-441–C5-446. https://doi.org/10.1051/jp4:1997570

How many times has this paper been cited?

1 times, according to OpenAlex on 22 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Journal de Physique IV (Proceedings): sign in and open the PDF from this page.

Who wrote this paper?

F. Nishimura, N. Watanabe, Kikuaki Tanaka.

What is the DOI of this paper?

10.1051/jp4:1997570, permanently at https://doi.org/10.1051/jp4:1997570. Sign in and open it from this page.

Bibliographic data from OpenAlex (CC0), last checked 22 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.