Journal article · 2002 · Open access

Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives

V. K. VERMA, Ramesh Singh, Vandana Srivastava, Preetam Singh

Indian Journal of Engineering and Materials Sciences, 9(3), 209–212 · Published 1 June 2002

Open full textCite this paper

In brief

“Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives” is a 2002 journal article by V. K. VERMA and 3 co-authors, published in Indian Journal of Engineering and Materials Sciences. OpenAlex counts 2 citations as of 17 November 2026. It is open access: the full text is free to read at Indian Journal of Engineering and Materials Sciences.

Citations
2
Most cited in
2020 (1)
Authors
4

Abstract

A number of blends of methylene-bis-[N.N-dialkyllalkylaryl dithiocarbamatesJ in paraffin oil (0.5% w/v) were evaluated .. for their anti-wear, EP and friction reducing tribological properties by employing 12.7 mm diameter low carbon and chro­ mium bearing ball specimen in a four ball test. All the additives were found to decrease wear and friction to appreciable lev­ els and increase the load carrying capacity to very high values. In particular, the additive methylene-bis-[morpholino­ dithiocarbamateJ was instrumental in exhibiting lower values of wear scar diameter and coefficient of friction at lower as well as higher loads and high load carrying capacity, load wear index and flash temperature parameter values in comparison to plain paraffin oil and a reference additive. The additives also afforded lower values of wear-scar diameter in one-hour wear test. The topography of the used bearing ball specimen was investigated by scanning microscopy technique. The automotive industry is a major market for lubri­ cants and extensively uses additive treated lubricants in engines, manual and automotive transmission and rear axles. The automobile gear teeth often experience severe wear and scuffing under the conditions of high specific pressures and temperatures. These deleterious effects can be minimized by using EP and anti-wear additive blended lubricants.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

VERMA, V. K., Singh, R., Srivastava, V., & Singh, P. (2002). Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives. Indian Journal of Engineering and Materials Sciences, 9(3), 209–212. http://nopr.niscair.res.in/bitstream/123456789/20080/1/IJEMS%209%283%29%20209-212.pdf

MLA 9

VERMA, V. K., et al. “Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives.” Indian Journal of Engineering and Materials Sciences, vol. 9, no. 3, 2002, pp. 209–212. http://nopr.niscair.res.in/bitstream/123456789/20080/1/IJEMS%209%283%29%20209-212.pdf.

Chicago

VERMA, V. K., Ramesh Singh, Vandana Srivastava, and Preetam Singh. 2002. “Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives.” Indian Journal of Engineering and Materials Sciences 9 (3): 209–212. http://nopr.niscair.res.in/bitstream/123456789/20080/1/IJEMS%209%283%29%20209-212.pdf.

Harvard

VERMA, V. K. et al. (2002) ‘Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives’, Indian Journal of Engineering and Materials Sciences, 9(3), pp. 209–212. Available at: http://nopr.niscair.res.in/bitstream/123456789/20080/1/IJEMS%209%283%29%20209-212.pdf.

IEEE

V. K. VERMA, R. Singh, V. Srivastava, and P. Singh, “Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives,” Indian Journal of Engineering and Materials Sciences, vol. 9, no. 3, pp. 209–212, 2002.

BibTeX

@article{verma2002tribology,
  title     = {{Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives}},
  author    = {VERMA, V. K. and Singh, Ramesh and Srivastava, Vandana and Singh, Preetam},
  journal   = {Indian Journal of Engineering and Materials Sciences},
  year      = {2002},
  volume    = {9},
  number    = {3},
  pages     = {209--212},
  url       = {http://nopr.niscair.res.in/bitstream/123456789/20080/1/IJEMS%209%283%29%20209-212.pdf}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Mechanical Engineering › Lubricants and Their Additives

  • antiwear additives
  • tribochemistry
  • friction reduction
  • wear scar diameter
  • bearing capacity
  • four-ball test
  • gear tooth wear
  • lubricant additives

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

VERMA, V. K., Singh, R., Srivastava, V., & Singh, P. (2002). Tribology and tribochemistry of oil soluble methylene-bis-[dialkyl/alkylaryl-dithiocarbamates] as potential EP additives. Indian Journal of Engineering and Materials Sciences, 9(3), 209–212. http://nopr.niscair.res.in/bitstream/123456789/20080/1/IJEMS%209%283%29%20209-212.pdf

How many times has this paper been cited?

2 times, according to OpenAlex on 17 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Indian Journal of Engineering and Materials Sciences: sign in and open the full text from this page.

Who wrote this paper?

V. K. VERMA, Ramesh Singh, Vandana Srivastava, Preetam Singh.

Bibliographic data from OpenAlex (CC0), last checked 17 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.