Journal article · 2000 · Open access

Synthesis of diamondlike carbon films with superlow friction and wear properties

Ali Erdemir, Osman Levent Eryilmaz, G.R. Fenske

Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 18(4), 1987–1992 · Published 1 July 2000 · DOI 10.1116/1.582459

Open PDFView at the publisherCite this paper

In brief

“Synthesis of diamondlike carbon films with superlow friction and wear properties” is a 2000 journal article by Ali Erdemir and 2 co-authors, published in Journal of Vacuum Science & Technology A Vacuum Surfaces and Films. OpenAlex counts 407 citations as of 17 November 2026, which puts it in the top 1% of works published in 2000 by citations. It is open access: the full text is free to read at Istanbul Technical University Academic Open Archive (Istanbul Technical University).

Citations
407
Most cited in
2020 (27)
Field-weighted impact
18.06
References
38
Authors
3

Abstract

In this study, we introduce a new diamondlike carbon (DLC) film providing a friction coefficient of 0.001 and wear rates of 10−9–10−10 mm3/N m in inert-gas environments (e.g., dry nitrogen and argon). The film was grown on steel and sapphire substrates in a plasma enhanced chemical vapor deposition system that uses a hydrogen-rich plasma. Employing a combination of surface and structure analytical techniques, we explored the structural chemistry of the resultant DLC films and correlated these findings with the friction and wear mechanisms of the films. The results of tribological tests under a 10 N load (creating initial peak Hertz pressures of 1 and 2.2 GPa on steel and sapphire test pairs, respectively) and at 0.2 to 0.5 m/s sliding velocities indicated that a close correlation exists between the friction and wear coefficients of DLC films and the source gas chemistry. Specifically, films grown in source gases with higher hydrogen-to-carbon ratios had the lowest friction coefficients and the highest wear resistance. The lowest friction coefficient (0.001) was achieved with a film on sapphire substrates produced in a gas discharge plasma consisting of 25% methane and 75% hydrogen.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Erdemir, A., Eryilmaz, O. L., & Fenske, G. (2000). Synthesis of diamondlike carbon films with superlow friction and wear properties. Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 18(4), 1987–1992. https://doi.org/10.1116/1.582459

MLA 9

Erdemir, Ali, et al. “Synthesis of diamondlike carbon films with superlow friction and wear properties.” Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, vol. 18, no. 4, 2000, pp. 1987–1992. https://doi.org/10.1116/1.582459.

Chicago

Erdemir, Ali, Osman Levent Eryilmaz, and G.R. Fenske. 2000. “Synthesis of diamondlike carbon films with superlow friction and wear properties.” Journal of Vacuum Science & Technology A Vacuum Surfaces and Films 18 (4): 1987–1992. https://doi.org/10.1116/1.582459.

Harvard

Erdemir, A., Eryilmaz, O. L. and Fenske, G. (2000) ‘Synthesis of diamondlike carbon films with superlow friction and wear properties’, Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 18(4), pp. 1987–1992. doi:10.1116/1.582459.

IEEE

A. Erdemir, O. L. Eryilmaz, and G. Fenske, “Synthesis of diamondlike carbon films with superlow friction and wear properties,” Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, vol. 18, no. 4, pp. 1987–1992, 2000, doi: 10.1116/1.582459.

BibTeX

@article{erdemir2000synthesis,
  title     = {{Synthesis of diamondlike carbon films with superlow friction and wear properties}},
  author    = {Erdemir, Ali and Eryilmaz, Osman Levent and Fenske, G.R.},
  journal   = {Journal of Vacuum Science \& Technology A Vacuum Surfaces and Films},
  year      = {2000},
  volume    = {18},
  number    = {4},
  pages     = {1987--1992},
  doi       = {10.1116/1.582459},
  url       = {https://doi.org/10.1116/1.582459}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
20171515
20181515
20191313
20202727
20211818
20221717
20231717
20242222
20251111
202699

Its field-weighted citation impact is 18.06: it has been cited 18.06 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Engineering › Mechanics of Materials › Metal and Thin Film Mechanics

  • diamond-like carbon films
  • superlow friction
  • wear resistance
  • plasma-enhanced chemical vapor deposition
  • H/C ratio
  • methane-hydrogen plasma
  • sapphire substrate
  • steel substrates

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Erdemir, A., Eryilmaz, O. L., & Fenske, G. (2000). Synthesis of diamondlike carbon films with superlow friction and wear properties. Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 18(4), 1987–1992. https://doi.org/10.1116/1.582459

How many times has this paper been cited?

407 times, according to OpenAlex on 17 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Istanbul Technical University Academic Open Archive (Istanbul Technical University): sign in and open the PDF from this page.

Who wrote this paper?

Ali Erdemir, Osman Levent Eryilmaz, G.R. Fenske.

What is the DOI of this paper?

10.1116/1.582459, permanently at https://doi.org/10.1116/1.582459. Sign in and open it from this page.

Bibliographic data from OpenAlex (CC0), last checked 17 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.