Journal article · 2013 · Open access

Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion

Kyun Taek Cho, Kyung Mee Song, Sang Ho Oh, Young‐Kook Lee, Won Beom Lee

Surface and Coatings Technology, 232, 912–919 · Published 6 July 2013 · DOI 10.1016/j.surfcoat.2013.06.123

Open full textCite this paper

In brief

“Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion” is a 2013 journal article by Kyun Taek Cho and 4 co-authors, published in Surface and Coatings Technology. OpenAlex counts 55 citations as of 22 November 2026. It is open access under a CC BY-NC-ND licence: the full text is free to read at Surface and Coatings Technology.

Citations
55
Most cited in
2018 (7)
Field-weighted impact
2.56
References
27
Authors
5

Abstract

A study was performed to investigate the surface hardening mechanism of H13 steel after shot peening and ion nitriding. The shot peening process was used as a pre-treatment causing severe plastic deformation to the specimen's surface. The ion nitriding process was then performed to a point where almost no compound layer on the top surface formed. The nitrided specimen after shot peening had a surface hardness of 1250 HV. This is approximately 300 HV higher than that of an ion nitrided specimen. The severe plastic deformation induced by the shot peening process resulted in nano-sized grains and numerous defects on the surface region. Nitrogen concentrations of the shot peened and nitrided specimen were still higher than that of a single nitrided specimen. In addition, chromium dissolved in the matrix regardless of pre-shot-peening treatment enhanced the bulk diffusion of nitrogen in the surface area of both nitrided specimens. This was shown via results from elemental mapping using transmission electron microscopy with electron energy loss spectroscopy (TEM-EELs). It was deduced that refined grains and higher nitrogen concentration acted as main factors for the surface hardening of shot peened and ion-nitrided specimen. Besides, lattice distortion caused by higher nitrogen concentration and abundant defects could be considered as the other factor for the surface hardening. (C), 2013 The Authors. Published by Elsevier B.V. All rights reserved.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Cho, K. T., Song, K. M., Oh, S. H., Lee, Y., & Lee, W. B. (2013). Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion. Surface and Coatings Technology, 232, 912–919. https://doi.org/10.1016/j.surfcoat.2013.06.123

MLA 9

Cho, Kyun Taek, et al. “Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion.” Surface and Coatings Technology, vol. 232, 2013, pp. 912–919. https://doi.org/10.1016/j.surfcoat.2013.06.123.

Chicago

Cho, Kyun Taek, Kyung Mee Song, Sang Ho Oh, Young‐Kook Lee, and Won Beom Lee. 2013. “Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion.” Surface and Coatings Technology 232: 912–919. https://doi.org/10.1016/j.surfcoat.2013.06.123.

Harvard

Cho, K. T. et al. (2013) ‘Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion’, Surface and Coatings Technology, 232, pp. 912–919. doi:10.1016/j.surfcoat.2013.06.123.

IEEE

K. T. Cho, K. M. Song, S. H. Oh, Y. Lee, and W. B. Lee, “Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion,” Surface and Coatings Technology, vol. 232, pp. 912–919, 2013, doi: 10.1016/j.surfcoat.2013.06.123.

BibTeX

@article{cho2013surface,
  title     = {{Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion}},
  author    = {Cho, Kyun Taek and Song, Kyung Mee and Oh, Sang Ho and Lee, Young‐Kook and Lee, Won Beom},
  journal   = {Surface and Coatings Technology},
  year      = {2013},
  volume    = {232},
  pages     = {912--919},
  doi       = {10.1016/j.surfcoat.2013.06.123},
  url       = {https://doi.org/10.1016/j.surfcoat.2013.06.123}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
201744
201877
201977
202055
202111
202277
202355
202455
202555
202633

Its field-weighted citation impact is 2.56: it has been cited 2.56 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Engineering › Mechanical Engineering › Surface Treatment and Residual Stress

  • surface hardening
  • shot peening
  • H13 steel
  • plasma nitriding
  • nitrogen diffusion
  • severe plastic deformation
  • grain refinement
  • chromium dissolution

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Cho, K. T., Song, K. M., Oh, S. H., Lee, Y., & Lee, W. B. (2013). Surface hardening of shot peened H13 steel by enhanced nitrogen diffusion. Surface and Coatings Technology, 232, 912–919. https://doi.org/10.1016/j.surfcoat.2013.06.123

How many times has this paper been cited?

55 times, according to OpenAlex on 22 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Surface and Coatings Technology: sign in and open the full text from this page.

Who wrote this paper?

Kyun Taek Cho, Kyung Mee Song, Sang Ho Oh, Young‐Kook Lee, Won Beom Lee.

What is the DOI of this paper?

10.1016/j.surfcoat.2013.06.123, permanently at https://doi.org/10.1016/j.surfcoat.2013.06.123. Sign in and open it from this page.

Bibliographic data from OpenAlex (CC0), last checked 22 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.