Dissertation · 2004 · Open access

Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production

J. Ballutaud

Infoscience (Ecole Polytechnique Fédérale de Lausanne) · Published 1 January 2004 · DOI 10.5075/epfl-thesis-2900

Free PDFView at the publisherCite this paper

In brief

“Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production” is a 2004 dissertation by J. Ballutaud, published in Infoscience (Ecole Polytechnique Fédérale de Lausanne). OpenAlex counts 5 citations as of 16 November 2026. It is open access under a CC BY-NC-ND licence: the full text is free to read at Infoscience (Ecole Polytechnique Fédérale de Lausanne).

Citations
5
Most cited in
2016 (2)
References
3
Authors
1

Abstract

Plasma enhanced chemical vapour deposition (PECVD) of thin films such as amorphous silicon has widespread applications especially in the field of photovoltaic solar cells and thin-film transistors for flat screen production. Industrial applications require high depositions rates over large areas with a good uniformity in layer thickness. In this thesis, some aspects of PECVD in large surface, industrial type, capacitive radio frequency reactor are investigated. The aim of this work is to study the plasma process conditions to increase the deposition rate of uniform, good quality, a-Si:H layer for solar cell application in a single chamber reactor. The studies realized during this thesis have necessitated the development and the comprehension of diagnostics such as deposition rate measurement by in-situ interferometry, plasma power measurement and layer density measurement by ellipsometry. During the thesis, we have also elaborated a matching-box circuit for using process frequencies of 27.12 MHz and 40.68 MHz. Deposition of a-Si:H in small electrode gap reactor has been studied. At present industrial reactors have a standard electrode gap of 2.4 cm. We modified a reactor to reach a small gap of 1.7 cm. It appears that we have obtained faster deposition rate in the small gap reactor but non-uniformity problems increase due to edge focusing and powder effects. One solution, based on a teflon jigsaw to keep the plasma away from the edge confined spaces, is proposed to suppress focusing effect but the operation parameter space is still reduced by the powder effect. Systematic measurements of a-Si:H layer density was also done by ellipsometry. It is shown that the layer density decreases when the deposition rate increases, independently of pressure, gas flow and frequency (27.12 MHz/40.68 MHz) of the plasma. At high deposition rate, 6 Å/s, only an increase of the process temperature from 200°C to 230°C can significantly improve the layer density. We have noted also a slight improvement of layer density for layers deposited in the small gap reactor. Nevertheless industrial constraints impose a process temperature of 200°C and a standard gap reactor. By optimising the process parameters, keeping the temperature process at 200°C, good quality, uniform, a-Si:H layer were deposited at 3 Å/s on 37 cm × 47 cm glass substrates at 40.68 MHz. A particular source of non-uniformity in large area reactor has been examined. In large area reactors, a perturbation in RF plasma potential, due to the electrode edge asymmetry, propagates towards the plasma center with a characteristic damping length λ. The variation of RF plasma potential at the edge implies a variation of…

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Ballutaud, J. (2004). Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production. Infoscience (Ecole Polytechnique Fédérale de Lausanne). https://doi.org/10.5075/epfl-thesis-2900

MLA 9

Ballutaud, J. “Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production.” Infoscience (Ecole Polytechnique Fédérale de Lausanne), 2004. https://doi.org/10.5075/epfl-thesis-2900.

Chicago

Ballutaud, J. 2004. “Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production.” Infoscience (Ecole Polytechnique Fédérale de Lausanne). https://doi.org/10.5075/epfl-thesis-2900.

Harvard

Ballutaud, J. (2004) ‘Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production’, Infoscience (Ecole Polytechnique Fédérale de Lausanne). doi:10.5075/epfl-thesis-2900.

IEEE

J. Ballutaud, “Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production,” Infoscience (Ecole Polytechnique Fédérale de Lausanne), 2004, doi: 10.5075/epfl-thesis-2900.

BibTeX

@phdthesis{ballutaud2004study,
  title     = {{Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production}},
  author    = {Ballutaud, J.},
  year      = {2004},
  doi       = {10.5075/epfl-thesis-2900},
  url       = {https://doi.org/10.5075/epfl-thesis-2900}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Low-Pressure Plasma Processing and Diagnostics

  • amorphous silicon
  • hydrogenated amorphous silicon
  • plasma-enhanced chemical vapor deposition
  • RF plasma
  • deposition rate
  • layer thickness uniformity
  • electrode gap
  • layer density

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Ballutaud, J. (2004). Study of radio-frequency plasma deposition of amorphous silicon for the improvement of solar cell production. Infoscience (Ecole Polytechnique Fédérale de Lausanne). https://doi.org/10.5075/epfl-thesis-2900

How many times has this paper been cited?

5 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at Infoscience (Ecole Polytechnique Fédérale de Lausanne).

Who wrote this paper?

J. Ballutaud.

What is the DOI of this paper?

10.5075/epfl-thesis-2900. The permanent link is https://doi.org/10.5075/epfl-thesis-2900.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.