Journal article · 2001 · Open access

Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s

A. Harv Mahan, Yueqin Xu, D. L. Williamson, Wolfhard Beyer, John D. Perkins, Milan Vanecek, Lynn M. Gedvilas, B. P. Nelson

Journal of Applied Physics, 90(10), 5038–5047 · Published 15 November 2001 · DOI 10.1063/1.1407317

Free PDFView at the publisherCite this paper

In brief

“Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s” is a 2001 journal article by A. Harv Mahan and 7 co-authors, published in Journal of Applied Physics. OpenAlex counts 81 citations as of 16 November 2026. It is open access: the full text is free to read at JuSER (Forschungszentrum Jülich).

Citations
81
Most cited in
2020 (5)
Field-weighted impact
8.68
References
45
Authors
8

Abstract

The structure of a-Si:H, deposited at rates in excess of 100 Å/s by the hot wire chemical vapor deposition technique, has been examined by x-ray diffraction (XRD), Raman spectroscopy, H evolution, and small-angle x-ray scattering (SAXS). The films examined in this study were chosen to have roughly the same bonded H content CH as probed by infrared spectroscopy. As the film deposition rate Rd is increased from 5 to >140 Å/s, we find that the short range order (from Raman), the medium range order (from XRD), and the peak position of the H evolution peak are invariant with respect to deposition rate, and exhibit structure consistent with a state-of-the-art, compact a-Si:H material deposited at low deposition rates. The only exception to this behavior is the SAXS signal, which increases by a factor of ∼100 over that for our best, low H content films deposited at ∼5 Å/s. We discuss the invariance of the short and medium range order in terms of growth models available in the literature, and relate changes in the film electronic structure (Urbach edge, as-grown defect density) to the increase in the SAXS signals. We also note the invariance of the saturated defect density versus Rd, measured after light soaking, and discuss possible reasons why the increase in the microvoid density apparently does not play a role in the Staebler–Wronski effect for this type of material.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Mahan, A. H., Xu, Y., Williamson, D. L., Beyer, W., Perkins, J. D., Vanecek, M., Gedvilas, L. M., & Nelson, B. P. (2001). Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s. Journal of Applied Physics, 90(10), 5038–5047. https://doi.org/10.1063/1.1407317

MLA 9

Mahan, A. Harv, et al. “Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s.” Journal of Applied Physics, vol. 90, no. 10, 2001, pp. 5038–5047. https://doi.org/10.1063/1.1407317.

Chicago

Mahan, A. Harv, Yueqin Xu, D. L. Williamson, Wolfhard Beyer, John D. Perkins, Milan Vanecek, Lynn M. Gedvilas, and B. P. Nelson. 2001. “Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s.” Journal of Applied Physics 90 (10): 5038–5047. https://doi.org/10.1063/1.1407317.

Harvard

Mahan, A. H. et al. (2001) ‘Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s’, Journal of Applied Physics, 90(10), pp. 5038–5047. doi:10.1063/1.1407317.

IEEE

A. H. Mahan et al., “Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s,” Journal of Applied Physics, vol. 90, no. 10, pp. 5038–5047, 2001, doi: 10.1063/1.1407317.

BibTeX

@article{mahan2001structural,
  title     = {{Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s}},
  author    = {Mahan, A. Harv and Xu, Yueqin and Williamson, D. L. and Beyer, Wolfhard and Perkins, John D. and Vanecek, Milan and Gedvilas, Lynn M. and Nelson, B. P.},
  journal   = {Journal of Applied Physics},
  year      = {2001},
  volume    = {90},
  number    = {10},
  pages     = {5038--5047},
  doi       = {10.1063/1.1407317},
  url       = {https://doi.org/10.1063/1.1407317}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
201544
201722
201811
201944
202055
202111
202222
202333
202411
202622

Its field-weighted citation impact is 8.68: it has been cited 8.68 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon and Solar Cell Technologies

  • hydrogenated amorphous silicon
  • hot filament chemical vapor deposition
  • high deposition rate
  • short-range order
  • medium-range order
  • hydrogen evolution reaction
  • Urbach edge
  • defect density

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Mahan, A. H., Xu, Y., Williamson, D. L., Beyer, W., Perkins, J. D., Vanecek, M., Gedvilas, L. M., & Nelson, B. P. (2001). Structural properties of hot wire a-Si:H films deposited at rates in excess of 100 Å/s. Journal of Applied Physics, 90(10), 5038–5047. https://doi.org/10.1063/1.1407317

How many times has this paper been cited?

81 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at JuSER (Forschungszentrum Jülich).

Who wrote this paper?

A. Harv Mahan, Yueqin Xu, D. L. Williamson, Wolfhard Beyer, John D. Perkins, Milan Vanecek, Lynn M. Gedvilas, B. P. Nelson.

What is the DOI of this paper?

10.1063/1.1407317. The permanent link is https://doi.org/10.1063/1.1407317.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.