Journal article · 2021 · Open access
Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation
Tribology International, 165, 107246 · Published 30 August 2021 · DOI 10.1016/j.triboint.2021.107246
In brief
“Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation” is a 2021 journal article by Alexandr S. Kuprin and 8 co-authors, published in Tribology International. OpenAlex counts 36 citations as of 20 November 2026, which puts it in the top 3% of works published in 2021 by citations. It is open access under a CC BY-NC-ND licence: the full text is free to read at Tribology International.
- Citations
- 36
- Most cited in
- 2025 (12)
- Field-weighted impact
- 2.25
- References
- 68
- Authors
- 9
Abstract
The Cr1−xVxN monolayer coatings were synthesized using vacuum arc plasma flux method. The properties of the coatings were compared with CrN and VN, i.e. for coatings where x = 0 or 1. The surface morphology, microstructure and chemical composition of (Cr,V)N coatings were investigated using Scanning Electron Microscopy (SEM) and Atomic Force Microscopy (AFM), X-ray Diffraction (XRD) and Energy Dispersive X-ray Spectroscopy (EDS). The mechanical and tribological properties of coatings were characterized using nano-indentation, scratch test and Daimler-Benz test and ball-on-disk tribometer. It was found that the cubic CrN phase was formed. In coatings with vanadium the solid solution (Cr,V)N phase was observed. The diffraction lines of the coatings were shifted to lower angles which indicated the stress occurring there. The roughness parameter Ra increased linearly with vanadium concentration, from about 0.05 µm (CrN) to about 0.13 µm (VN) which was probably connected with significantly higher number of surface defects. The hardness and elastic modulus of Cr1−xVxN coatings increased from 20 GPa (CrN) to 35 GPa (VN) and 300 GPa (CrN) to about 500 GPa (VN) respectively. Adhesion of the coatings was very high. The critical load of the complete coating detachment exceeds 100 N. The highest wear rate was for CrN coating - (1.7 ± 0.1) × 10−6 mm3/Nm, while the lowest was for VN coating - (1.2 ± 0.6) × 10−7 mm3/Nm. The wear mechanism for all coatings against Al2O3 ball was mainly abrasive. The VN coating showed the lowest friction coefficient in the set of coatings investigated.
Cite this paper
Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.
APA 7
Kuprin, A. S., Ovcharenko, V. D., Gilewicz, A., Tolmachova, G. N., Kolodiy, I. V., Vasilenko, R. L., Кузнецова, Т. А., Lapitskaya, V. A., & Warcholiński, B. (2021). Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation. Tribology International, 165, 107246. https://doi.org/10.1016/j.triboint.2021.107246
MLA 9
Kuprin, Alexandr S., et al. “Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation.” Tribology International, vol. 165, 2021, p. 107246. https://doi.org/10.1016/j.triboint.2021.107246.
Chicago
Kuprin, Alexandr S., Valeriy D. Ovcharenko, Adam Gilewicz, Galyna N. Tolmachova, Igor V. Kolodiy, Ruslan L. Vasilenko, Т. А. Кузнецова, Vasilina A. Lapitskaya, and Bogdan Warcholiński. 2021. “Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation.” Tribology International 165: 107246. https://doi.org/10.1016/j.triboint.2021.107246.
Harvard
Kuprin, A. S. et al. (2021) ‘Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation’, Tribology International, 165, p. 107246. doi:10.1016/j.triboint.2021.107246.
IEEE
A. S. Kuprin et al., “Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation,” Tribology International, vol. 165, p. 107246, 2021, doi: 10.1016/j.triboint.2021.107246.
BibTeX
@article{kuprin2021structural,
title = {{Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation}},
author = {Kuprin, Alexandr S. and Ovcharenko, Valeriy D. and Gilewicz, Adam and Tolmachova, Galyna N. and Kolodiy, Igor V. and Vasilenko, Ruslan L. and Кузнецова, Т. А. and Lapitskaya, Vasilina A. and Warcholiński, Bogdan},
journal = {Tribology International},
year = {2021},
volume = {165},
pages = {107246},
doi = {10.1016/j.triboint.2021.107246},
url = {https://doi.org/10.1016/j.triboint.2021.107246}
}
Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)
Citations by year
| Year | Citations | Share of the best year |
|---|---|---|
| 2022 | 5 | |
| 2023 | 8 | |
| 2024 | 7 | |
| 2025 | 12 | |
| 2026 | 4 |
Its field-weighted citation impact is 2.25: it has been cited 2.25 times as often as the average work of the same field, type and year (1.00 is the world average).
Topic and keywords
Physical Sciences › Engineering › Mechanics of Materials › Metal and Thin Film Mechanics
- chromium nitride
- vanadium nitride
- cathodic arc deposition
- solid solutions
- residual stress
- surface roughness
- hardness
- elastic modulus
Work with this paper
Most-cited papers in Engineering
- A Closed‐form Equation for Predicting the Hydraulic Conductivity of Unsaturated SoilsMartinus Th. van Genuchten · Soil Science Society of America Journal · 1980 · 28,197 citations
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsW. C. Oliver, George M. Pharr · Journal of materials research/Pratt's guide to venture capital sources · 1992 · 27,379 citations
- Digital communicationsOwen Bishop · Routledge eBooks · 2007 · 24,890 citations
- The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysisNorden Eh Huang, Zhengwei Shen, Steven R. Long and 6 more · Proceedings of the Royal Society A Mathematical Physical and Engineering Sciences · 1998 · 24,008 citations
- Numerical Heat Transfer and Fluid FlowSuhas V. Patankar · CRC Press eBooks · 2018 · 23,491 citations
Questions about this paper
How do I cite this paper in APA style?
Kuprin, A. S., Ovcharenko, V. D., Gilewicz, A., Tolmachova, G. N., Kolodiy, I. V., Vasilenko, R. L., Кузнецова, Т. А., Lapitskaya, V. A., & Warcholiński, B. (2021). Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation. Tribology International, 165, 107246. https://doi.org/10.1016/j.triboint.2021.107246
How many times has this paper been cited?
36 times, according to OpenAlex on 20 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.
Is this paper free to read?
Yes. It is open access at Tribology International: sign in and open the PDF from this page.
Who wrote this paper?
Alexandr S. Kuprin, Valeriy D. Ovcharenko, Adam Gilewicz, Galyna N. Tolmachova, Igor V. Kolodiy, Ruslan L. Vasilenko, Т. А. Кузнецова, Vasilina A. Lapitskaya, Bogdan Warcholiński.
What is the DOI of this paper?
10.1016/j.triboint.2021.107246, permanently at https://doi.org/10.1016/j.triboint.2021.107246. Sign in and open it from this page.
Bibliographic data from OpenAlex (CC0), last checked 20 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.