Journal article · 1986 · Open access
Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing
Journal of The Electrochemical Society, 133(7), 1451–1458 · Published 1 July 1986 · DOI 10.1149/1.2108933
In brief
“Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing” is a 1986 journal article by T. Brat and 4 co-authors, published in Journal of The Electrochemical Society. OpenAlex counts 38 citations as of 16 November 2026. It is open access: the full text is free to read at Journal of The Electrochemical Society.
- Citations
- 38
- Most cited in
- 2016 (2)
- Field-weighted impact
- 3.80
- Authors
- 5
Abstract
Different aspects of the reaction between Ti and single‐crystal (100) Si are reported when the reaction is thermally activated by rapid thermal annealing. The sheet resistance variation of the film was measured for a wide range of annealing temperatures, from 400° to 1100°C, in two different atmospheres of high purity Ar and gas, for bare and As‐implanted Si. At temperatures ⩾800°C, the only silicide formed was . Both cross‐sectional TEM and RBS results indicate that the amount of titanium consumed in the reaction depends strongly on the atmosphere used for silicidation. Argon makes possible the reaction of almost the whole Ti layer with silicon, while nitrogen leaves an unreacted layer of about 15 nm, independent of the thickness of the original film. A two‐step anneal is necessary to eliminate bridging in a patterned oxide structure. No difference was observed in the roughness of the external surface whether the samples were annealed in Ar or in . No significant enhanced diffusion of As into Si was observed near the interface after RTA in an Ar ambient, while a redistribution of As into the silicide takes place. The As piles up at the surface, from which it evaporates at high temperatures. Results of furnace‐annealed samples in atmosphere show a pile‐up of As at the and the atmosphere interfaces, where it evaporates from the latter, at high temperatures.
Cite this paper
Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.
APA 7
Brat, T., Osburn, C. M., Finstad, T. G., Liu, J., & Ellington, B. (1986). Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing. Journal of The Electrochemical Society, 133(7), 1451–1458. https://doi.org/10.1149/1.2108933
MLA 9
Brat, T., et al. “Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing.” Journal of The Electrochemical Society, vol. 133, no. 7, 1986, pp. 1451–1458. https://doi.org/10.1149/1.2108933.
Chicago
Brat, T., C. M. Osburn, T. G. Finstad, J. Liu, and Beth Ellington. 1986. “Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing.” Journal of The Electrochemical Society 133 (7): 1451–1458. https://doi.org/10.1149/1.2108933.
Harvard
Brat, T. et al. (1986) ‘Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing’, Journal of The Electrochemical Society, 133(7), pp. 1451–1458. doi:10.1149/1.2108933.
IEEE
T. Brat, C. M. Osburn, T. G. Finstad, J. Liu, and B. Ellington, “Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing,” Journal of The Electrochemical Society, vol. 133, no. 7, pp. 1451–1458, 1986, doi: 10.1149/1.2108933.
BibTeX
@article{brat1986self,
title = {{Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing}},
author = {Brat, T. and Osburn, C. M. and Finstad, T. G. and Liu, J. and Ellington, Beth},
journal = {Journal of The Electrochemical Society},
year = {1986},
volume = {133},
number = {7},
pages = {1451--1458},
doi = {10.1149/1.2108933},
url = {https://doi.org/10.1149/1.2108933}
}
Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)
Citations by year
| Year | Citations | Share of the best year |
|---|---|---|
| 2016 | 2 | |
| 2017 | 1 | |
| 2024 | 1 | |
| 2026 | 1 |
Its field-weighted citation impact is 3.80: it has been cited 3.80 times as often as the average work of the same field, type and year (1.00 is the world average).
Topic and keywords
Physical Sciences › Materials Science › Electronic, Optical and Magnetic Materials › Semiconductor materials and interfaces
- titanium silicide
- rapid thermal annealing
- self-aligned silicide
- monocrystalline silicon
- sheet resistance
- argon atmosphere
- nitrogen atmosphere
- arsenic implantation
Work with this paper
Most-cited papers in Materials Science
- Electric Field Effect in Atomically Thin Carbon FilmsKostya S. Novoselov, Andre K. Geim, Sergey V. Morozov and 5 more · Science · 2004 · 67,474 citations
- Revised effective ionic radii and systematic studies of interatomic distances in halides and chalcogenidesROBERT D. SHANNON · Acta Crystallographica Section A · 1976 · 66,944 citations
- Ab initio molecular dynamics for liquid metalsGeorg Kresse, J. Häfner · Physical review. B, Condensed matter · 1993 · 46,320 citations
- Helical microtubules of graphitic carbonSumio Iijima · Nature · 1991 · 43,639 citations
- The rise of grapheneAndre K. Geim, Kostya S. Novoselov · Nature Materials · 2007 · 40,328 citations
Questions about this paper
How do I cite this paper in APA style?
Brat, T., Osburn, C. M., Finstad, T. G., Liu, J., & Ellington, B. (1986). Self‐Aligned Ti Silicide Formed by Rapid Thermal Annealing. Journal of The Electrochemical Society, 133(7), 1451–1458. https://doi.org/10.1149/1.2108933
How many times has this paper been cited?
38 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.
Is this paper free to read?
Yes. It is open access: read the free full text at Journal of The Electrochemical Society.
Who wrote this paper?
T. Brat, C. M. Osburn, T. G. Finstad, J. Liu, Beth Ellington.
What is the DOI of this paper?
10.1149/1.2108933. The permanent link is https://doi.org/10.1149/1.2108933.
Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.