Journal article · 2025 · Open access

Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution

Jing Luan, Bingyang Ma, Songtao Dong, Lei Wang, Changpan Mo, Hongbo Ju

Surface and Coatings Technology, 514, 132546 · Published 8 August 2025 · DOI 10.1016/j.surfcoat.2025.132546

Open full textCite this paper

In brief

“Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution” is a 2025 journal article by Jing Luan and 5 co-authors, published in Surface and Coatings Technology. OpenAlex counts 6 citations as of 17 November 2026, which puts it in the top 3% of works published in 2025 by citations. It is open access under a CC BY-NC licence: the full text is free to read at Surface and Coatings Technology.

Citations
6
Most cited in
2026 (6)
Field-weighted impact
1.05
References
46
Authors
6

Abstract

Green lubricant development remains a key challenge for zero-friction, zero-emission technologies. In this work, Cr–Mo–N/Ag composite films were engineered by integrating a CrN hard matrix with the self-lubricating effects of Ag and Mo, and deposited via RF magnetron sputtering with varying Mo content. All films exhibited a dual-phase structure of fcc-CrN and fcc Ag. Mo incorporation below 17.7 at.% enhanced hardness and elastic modulus to around 22 GPa and 280 GPa, respectively. At room temperature, Mo addition up to 17.7 at.% reduced the coefficient of friction (COF) and wear rate (WR) to about 0.45 and 3.5 × 10 −6 mm 3 /N·mm, attributed to matrix hardening, Ag-induced lubricity, and tribo-oxide formation. At 500 °C, the COF further dropped to 0.21 for the 22.6 at.% Mo film due to the formation of low-shear tribo-oxides (MoO₃, Ag₂MoO₄, Ag₂Mo₄O₁₃). However, excessive debris adhesion hindered accurate WR measurement. These results highlight an effective strategy for designing robust, self-lubricating coatings for harsh thermal environments. • The Cr–Mo–N/Ag film was deposited using RF magnetron sputtering system. • The incorporation of Mo enhanced the hardness from 17 GPa for the CrN/Ag reference to 22 GPa. • At 500 °C, the COF continued to decrease to reach as low as 0.21 for the 22.6 at.% Mo film. • The optimized composition of 17.7 at.% Mo achieved a balance between hardness and tribological performance.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Luan, J., Ma, B., Dong, S., Wang, L., Mo, C., & Ju, H. (2025). Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution. Surface and Coatings Technology, 514, 132546. https://doi.org/10.1016/j.surfcoat.2025.132546

MLA 9

Luan, Jing, et al. “Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution.” Surface and Coatings Technology, vol. 514, 2025, p. 132546. https://doi.org/10.1016/j.surfcoat.2025.132546.

Chicago

Luan, Jing, Bingyang Ma, Songtao Dong, Lei Wang, Changpan Mo, and Hongbo Ju. 2025. “Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution.” Surface and Coatings Technology 514: 132546. https://doi.org/10.1016/j.surfcoat.2025.132546.

Harvard

Luan, J. et al. (2025) ‘Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution’, Surface and Coatings Technology, 514, p. 132546. doi:10.1016/j.surfcoat.2025.132546.

IEEE

J. Luan, B. Ma, S. Dong, L. Wang, C. Mo, and H. Ju, “Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution,” Surface and Coatings Technology, vol. 514, p. 132546, 2025, doi: 10.1016/j.surfcoat.2025.132546.

BibTeX

@article{luan2025self,
  title     = {{Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution}},
  author    = {Luan, Jing and Ma, Bingyang and Dong, Songtao and Wang, Lei and Mo, Changpan and Ju, Hongbo},
  journal   = {Surface and Coatings Technology},
  year      = {2025},
  volume    = {514},
  pages     = {132546},
  doi       = {10.1016/j.surfcoat.2025.132546},
  url       = {https://doi.org/10.1016/j.surfcoat.2025.132546}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Mechanics of Materials › Metal and Thin Film Mechanics

  • self-lubricating coatings
  • molybdenum content
  • friction coefficient
  • wear rate
  • high-temperature tribology
  • hardness
  • elastic modulus
  • green lubricants

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Luan, J., Ma, B., Dong, S., Wang, L., Mo, C., & Ju, H. (2025). Self-lubricating mechanisms in magnetron-sputtered Cr–Mo–N/Ag composite films: Role of Mo content and tribo-oxide evolution. Surface and Coatings Technology, 514, 132546. https://doi.org/10.1016/j.surfcoat.2025.132546

How many times has this paper been cited?

6 times, according to OpenAlex on 17 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Surface and Coatings Technology: sign in and open the full text from this page.

Who wrote this paper?

Jing Luan, Bingyang Ma, Songtao Dong, Lei Wang, Changpan Mo, Hongbo Ju.

What is the DOI of this paper?

10.1016/j.surfcoat.2025.132546, permanently at https://doi.org/10.1016/j.surfcoat.2025.132546. Sign in and open it from this page.

Bibliographic data from OpenAlex (CC0), last checked 17 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.