Dissertation · 2013 · Open access

Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries

Yan Hong Zhao

UWSpace (University of Waterloo) · Published 29 August 2013

Open full textCite this paper

In brief

“Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries” is a 2013 dissertation by Yan Hong Zhao, published in UWSpace (University of Waterloo). OpenAlex counts 0 citations as of 18 November 2026. It is open access: the full text is free to read at UWSpace (University of Waterloo).

Citations
0
References
119
Authors
1

Abstract

With the rapid development of portable electronics, hybrid-electric and electric cars, there is great interest in utilization of sulfur as cathodes for rechargeable lithium batteries. Lithium/sulfur batteries implement inexpensive, the earth-abundant elements at the cathode while offering up to a five-fold increase in energy density compared with the present Li-ion batteries. However, electrically insulating character of sulfur and solubility of intermediate polysulfides in organic liquid electrolytes, which causes rapid capacity loss upon repeated cycling, restrict the practical application of Li/S batteries. \n \nIn this thesis, the gel polymer and solid polymer electrolytes were synthesized and applied in Li/S batteries. A gel polymer electrolyte (GPE) was formed by trapping 1 M lithium bistrifluoromethane-sulfonamide (LiTFSI) in tetraethylene glycol dimethyl ether (TEGDME) electrolyte in a poly(vinylidenefluoride-co-hexafluoropropylene) (PVDF-HFP) /poly(methylmethacrylate) (PMMA) polymer matrix. The electrochemical properties of the resulting GPE were investigated in lithium/sulfur battery. The gel polymer battery exhibited a high specific capacity of 753.8 mAh gˉ¹ at the initial cycle, stable reversible cycling and a capacity retention about 80% over 40 cycles along with a high Coulombic efficiency. Comparative studies conducted with the 1 M LiTFSI liquid electrolyte cell demonstrated that a cell with liquid electrolyte has remarkably low capacity retention and Coulombic efficiency compared with the GPE cell. In the further studies, a solid polymer electrolyte (SPE) based on poly- (ethylene-oxide)/nanoclay composite was prepared and used to assemble an all-solid-state lithium/sulfur battery. The ionic conductivity of the optimized electrolyte has achieved about 3.22×10ˉ¹ mS cmˉ¹ at 60 °C. The Li/S cell with this SPE delivered an initial discharge capacity of 998 mAh gˉ¹ when operated at 60 °C, and retained a reversible capacity of 634 mAh gˉ¹ after 100 cycles. These studies has revealed that the electrochemical performance of lithium/sulfur cells, including charge-discharge cyclability and Coulombic efficiency, can be significantly improved by replacing liquid electrolytes with solid polymer and gel polymer electrolytes, which reduce the polysulfide shuttle effect and could protect the lithium anode from the deposition of the electrochemical reaction, leading to higher sulfur utilization in the cell.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Zhao, Y. H. (2013). Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries. UWSpace (University of Waterloo). http://hdl.handle.net/10012/7768

MLA 9

Zhao, Yan Hong. “Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries.” UWSpace (University of Waterloo), 2013. http://hdl.handle.net/10012/7768.

Chicago

Zhao, Yan Hong. 2013. “Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries.” UWSpace (University of Waterloo). http://hdl.handle.net/10012/7768.

Harvard

Zhao, Y. H. (2013) ‘Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries’, UWSpace (University of Waterloo). Available at: http://hdl.handle.net/10012/7768.

IEEE

Y. H. Zhao, “Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries,” UWSpace (University of Waterloo), 2013.

BibTeX

@phdthesis{zhao2013polymer,
  title     = {{Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries}},
  author    = {Zhao, Yan Hong},
  year      = {2013},
  url       = {http://hdl.handle.net/10012/7768}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced Battery Materials and Technologies

  • lithium-sulfur batteries
  • gel polymer electrolyte
  • solid polymer electrolytes
  • polysulfide shuttle effect
  • lithium polysulfides
  • LiTFSI
  • tetraethylene glycol dimethyl ether
  • all-solid-state batteries

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Zhao, Y. H. (2013). Polymer Electrolytes for Rechargeable Lithium/Sulfur Batteries. UWSpace (University of Waterloo). http://hdl.handle.net/10012/7768

How many times has this paper been cited?

0 times, according to OpenAlex on 18 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at UWSpace (University of Waterloo): sign in and open the full text from this page.

Who wrote this paper?

Yan Hong Zhao.

Bibliographic data from OpenAlex (CC0), last checked 18 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.