Journal article · 2011 · Open access

Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films

Dooho Choi, Bincheng Wang, Suk Chung, Xuan Liu, Amith Darbal, Adam Wise, Noel Thomas Nuhfer, Katayun Barmak, Andrew P. Warren, Kevin R. Coffey, Michael F. Toney

Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 29(5) · Published 15 August 2011 · DOI 10.1116/1.3622619

Read the free full textView at the publisherCite this paper

In brief

“Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films” is a 2011 journal article by Dooho Choi and 10 co-authors, published in Journal of Vacuum Science & Technology A Vacuum Surfaces and Films. OpenAlex counts 124 citations as of 16 November 2026, which puts it in the top 7% of works published in 2011 by citations. It is open access: the full text is free to read at Journal of International Crisis and Risk Communication Research.

Citations
124
Most cited in
2019 (14)
Field-weighted impact
4.76
References
38
Authors
11

Abstract

Sputter-deposited W films with nominal thicknesses between 5 and 180 nm were prepared by varying the base pressure prior to film deposition and by including or not including sputtered SiO2 encapsulation layers. X-ray and electron diffraction studies showed that single phase, polycrystalline α-W could be achieved in as-deposited films as thin as 5 nm. The stress state in the as-deposited films was found to be inhomogeneous. Annealing resulted in stress relaxation and reduction of resistivity for all films, except the thinnest, unencapsulated film, which agglomerated. In-plane film grain sizes measured for a subset of the annealed films with thicknesses between 5 and 180 nm surprisingly showed a near constant value (101–116 nm), independent of film thickness. Thick-film (≥120 nm) resistivity values as low as 8.6 μΩ cm at 301 K were obtained after annealing at 850 °C for 2 h. Film resistivities were found to increase with decreasing film thicknesses below 120 nm, even for films which are fully A2 α-W with no metastable, A15 β-W evident.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Choi, D., Wang, B., Chung, S., Liu, X., Darbal, A., Wise, A., Nuhfer, N. T., Barmak, K., Warren, A. P., Coffey, K. R., & Toney, M. F. (2011). Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films. Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 29(5). https://doi.org/10.1116/1.3622619

MLA 9

Choi, Dooho, et al. “Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films.” Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, vol. 29, no. 5, 2011. https://doi.org/10.1116/1.3622619.

Chicago

Choi, Dooho, Bincheng Wang, Suk Chung, Xuan Liu, Amith Darbal, Adam Wise, Noel Thomas Nuhfer, et al. 2011. “Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films.” Journal of Vacuum Science & Technology A Vacuum Surfaces and Films 29 (5). https://doi.org/10.1116/1.3622619.

Harvard

Choi, D. et al. (2011) ‘Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films’, Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 29(5). doi:10.1116/1.3622619.

IEEE

D. Choi et al., “Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films,” Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, vol. 29, no. 5, 2011, doi: 10.1116/1.3622619.

BibTeX

@article{choi2011phase,
  title     = {{Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films}},
  author    = {Choi, Dooho and Wang, Bincheng and Chung, Suk and Liu, Xuan and Darbal, Amith and Wise, Adam and Nuhfer, Noel Thomas and Barmak, Katayun and Warren, Andrew P. and Coffey, Kevin R. and Toney, Michael F.},
  journal   = {Journal of Vacuum Science \& Technology A Vacuum Surfaces and Films},
  year      = {2011},
  volume    = {29},
  number    = {5},
  doi       = {10.1116/1.3622619},
  url       = {https://doi.org/10.1116/1.3622619}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
20171212
201844
20191414
202088
20211212
20221414
20231212
202488
20251010
202644

Its field-weighted citation impact is 4.76: it has been cited 4.76 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Engineering › Mechanics of Materials › Metal and Thin Film Mechanics

  • tungsten thin films
  • sputter deposition
  • beta-tungsten
  • film stress
  • electrical resistivity
  • grain size
  • annealing
  • stress relaxation

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Choi, D., Wang, B., Chung, S., Liu, X., Darbal, A., Wise, A., Nuhfer, N. T., Barmak, K., Warren, A. P., Coffey, K. R., & Toney, M. F. (2011). Phase, grain structure, stress, and resistivity of sputter-deposited tungsten films. Journal of Vacuum Science & Technology A Vacuum Surfaces and Films, 29(5). https://doi.org/10.1116/1.3622619

How many times has this paper been cited?

124 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at Journal of International Crisis and Risk Communication Research.

Who wrote this paper?

Dooho Choi, Bincheng Wang, Suk Chung, Xuan Liu, Amith Darbal, Adam Wise, Noel Thomas Nuhfer, Katayun Barmak, Andrew P. Warren, Kevin R. Coffey, Michael F. Toney.

What is the DOI of this paper?

10.1116/1.3622619. The permanent link is https://doi.org/10.1116/1.3622619.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.