Dissertation · 2015 · Open access

Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys

Li-Wei Tseng

OakTrust (Texas A&M University Libraries) · Published 5 May 2015

Open full textCite this paper

In brief

“Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys” is a 2015 dissertation by Li-Wei Tseng, published in OakTrust (Texas A&M University Libraries). OpenAlex counts 6 citations as of 22 November 2026. It is open access: the full text is free to read at OakTrust (Texas A&M University Libraries).

Citations
6
Most cited in
2023 (3)
References
88
Authors
1

Abstract

Fe43.5Mn34Al15Ni7.5 shape memory alloys have attracted attention as potential superelasticity alloys in server environments, capable of exhibiting good superelastic behavior with up to 5% recoverable strain over a wide temperature range from -196°C to 240°C. The objective of this work is to investigate the effects of martensite variants, aging heat treatment, crystal orientations and grain size on the superelastic properties. Although the theoretical transformation strain of single crystal with the orientation in tension (26.5%) is higher than it is in compression (10.5%), the compression sample shows a better recoverable strain than that in the tension sample from the experimental results. The differences in reversibility and the shape of the stress-strain curves under tension and compression are attributed to the lower number of martensite variants activated under tension as compared to compression. The effect of aging has profound influences on the size and volume fraction of precipitates, transformation temperatures, stress-temperature phase diagram, recoverable strain and stress hysteresis. Increasing the aging times improves the superelastic strain in compression and decreases it in tension. The reason for these is related to the selection of martensite variants. The crystal orientations affect the superelastic properties such as the stress-temperature phase diagram and transformation strain. The differences in the slope of the stress-temperature curves and critical stress in different orientation are attributed to the transformation strain and resolved shear stress factors, respectively. Aging heat treatment decreases the orientation effect on slope of stress-temperature curve. The sheet is brittle (high hardness values) after being hot-rolled which causes to appear after the cold-rolled experiment. The hot-rolled sheet was annealing at 900°C for 1 hour to obtain two phases (bcc+fcc) and ductility (small hardness values). Therefore, cold-rolling of the annealing sheet is practical up to 76%. The large grain size can be obtained by repetition of the heat treatment. Increasing the grain sizes improves the superelastic strain due to reduction of grain boundary constraints.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Tseng, L.-W. (2015). Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys. OakTrust (Texas A&M University Libraries). https://hdl.handle.net/1969.1/161246

MLA 9

Tseng, Li-Wei. “Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys.” OakTrust (Texas A&M University Libraries), 2015. https://hdl.handle.net/1969.1/161246.

Chicago

Tseng, Li-Wei. 2015. “Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys.” OakTrust (Texas A&M University Libraries). https://hdl.handle.net/1969.1/161246.

Harvard

Tseng, L.-W. (2015) ‘Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys’, OakTrust (Texas A&M University Libraries). Available at: https://hdl.handle.net/1969.1/161246.

IEEE

L.-W. Tseng, “Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys,” OakTrust (Texas A&M University Libraries), 2015.

BibTeX

@phdthesis{tseng2015microstructure,
  title     = {{Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys}},
  author    = {Tseng, Li-Wei},
  year      = {2015},
  url       = {https://hdl.handle.net/1969.1/161246}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
202111
202211
202333
202411

Topic and keywords

Physical Sciences › Materials Science › Materials Chemistry › Shape Memory Alloy Transformations

  • superelasticity
  • martensite variants
  • aging treatment
  • crystal orientation effects
  • grain size effects
  • recoverable strain
  • transformation strain
  • stress hysteresis

Work with this paper

Most-cited papers in Materials Science

All highly cited Materials Science papers

Questions about this paper

How do I cite this paper in APA style?

Tseng, L.-W. (2015). Microstructure and Superelastic Response of Iron-Based Shape Memory Alloys. OakTrust (Texas A&M University Libraries). https://hdl.handle.net/1969.1/161246

How many times has this paper been cited?

6 times, according to OpenAlex on 22 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at OakTrust (Texas A&M University Libraries): sign in and open the full text from this page.

Who wrote this paper?

Li-Wei Tseng.

Bibliographic data from OpenAlex (CC0), last checked 22 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.