Dissertation · 2016 · Open access

Interfaces in amorphous/crystalline silicon heterojunction solar cells

Mathias Mews

DepositOnce · Published 1 January 2016 · DOI 10.14279/depositonce-5396

Read the free full textView at the publisherCite this paper

In brief

“Interfaces in amorphous/crystalline silicon heterojunction solar cells” is a 2016 dissertation by Mathias Mews, published in DepositOnce. OpenAlex counts 1 citations as of 16 November 2026. It is open access: the full text is free to read at HZB Repository (Helmholtz-Zentrum Berlin für Materialien und Energie GmbH (HZB)).

Citations
1
Most cited in
2020 (1)
References
223
Authors
1

Abstract

The passivation of the amorphous/crystalline silicon heterojunction (SHJ) and the hole transport across the same are the dominating topics in this thesis. The different chapters focus on: The influence of hydrogen on SHJ passivation and an alternative passivation process for surfaces with higher surface free energy, the application of anti-reflection nanostructures and the current generation in these structures, the application of a novel liquid precursor for SHJ passivation, the investigation of its conversion process and the differences between the resulting layer and PECV deposited a-Si:H layers, the transport across the SHJ and its dependence on the valence band offset and the future research topics for silicon heterojunction solar cells. Chapter 4 comprised an investigation of a two step process for the fabrication of (i)a-Si:H passivation layers on non-ideal c-Si surfaces. The more common approach of directly depositing the best possible passivation layer in a single step is sensitive to surface properties, such as the higher surface free energy of the (100) surface, and results in higher defect densities at Si-(100), or crystallographically undefined surfaces, than on Si-(111). Using a two-step approach allows to deposit structurally worse a-Si:H layers first. These layers are less likely to form epitaxial regions on surfaces with higher free surface energies. In a second step the layer is then exposed to a hydrogen plasma treatment, which allows to introduce additional hydrogen into the layer and reduce the structural disorder. The two step approach allows to form an epitaxy free and hydrogen rich interface at the SHJ. Chapter 5 describes the application of the aforementioned method to passivate nanotextured silicon surfaces with (i)a-Si:H. The technological question in this project was to enable epitaxy free (i)a-Si:H growth on the crystallographically undefined nanotexture and then apply a hydrogen plasma, which improves the structural quality of the layer, but does not induce crystallization. Additionally the nanotextured solar cells featured a low quantum efficiency at the shorter wavelengths of the visible spectrum. It was deduced from simulations that this low quantum efficiency is based on parasitic absorption in crystalline silicon and a follow-up experiment with nanotextures of varied height enabled to show that this parasitic absorption happens inside the nanotexture. The work on liquid silicon precursors for SHJ passivation is another application for the hydrogen plasma developed in chapter 4. In contrast to the previous application, the structural quality of the as-deposited a-Si:H layers was acceptable, as shown by photo electron spectroscopy measurements of the valence band. Amorphous silicon layers prepared from liquid precursors feature low hydrogen densities. Also, these layers…

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Mews, M. (2016). Interfaces in amorphous/crystalline silicon heterojunction solar cells. DepositOnce. https://doi.org/10.14279/depositonce-5396

MLA 9

Mews, Mathias. “Interfaces in amorphous/crystalline silicon heterojunction solar cells.” DepositOnce, 2016. https://doi.org/10.14279/depositonce-5396.

Chicago

Mews, Mathias. 2016. “Interfaces in amorphous/crystalline silicon heterojunction solar cells.” DepositOnce. https://doi.org/10.14279/depositonce-5396.

Harvard

Mews, M. (2016) ‘Interfaces in amorphous/crystalline silicon heterojunction solar cells’, DepositOnce. doi:10.14279/depositonce-5396.

IEEE

M. Mews, “Interfaces in amorphous/crystalline silicon heterojunction solar cells,” DepositOnce, 2016, doi: 10.14279/depositonce-5396.

BibTeX

@phdthesis{mews2016interfaces,
  title     = {{Interfaces in amorphous/crystalline silicon heterojunction solar cells}},
  author    = {Mews, Mathias},
  year      = {2016},
  doi       = {10.14279/depositonce-5396},
  url       = {https://doi.org/10.14279/depositonce-5396}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon and Solar Cell Technologies

  • surface passivation
  • hydrogen plasma treatment
  • hydrogenated amorphous silicon
  • hole transport
  • valence band offset
  • parasitic absorption
  • surface energy
  • crystallization

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Mews, M. (2016). Interfaces in amorphous/crystalline silicon heterojunction solar cells. DepositOnce. https://doi.org/10.14279/depositonce-5396

How many times has this paper been cited?

1 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at HZB Repository (Helmholtz-Zentrum Berlin für Materialien und Energie GmbH (HZB)).

Who wrote this paper?

Mathias Mews.

What is the DOI of this paper?

10.14279/depositonce-5396. The permanent link is https://doi.org/10.14279/depositonce-5396.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.