Journal article · 2018 · Open access

Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys

Uwe Arlic, Hennadiy Zak, B. Weidenfeller, Werner Riehemann

Materials Research, 21(suppl 2) · Published 19 July 2018 · DOI 10.1590/1980-5373-mr-2017-0897

Open PDFView at the publisherCite this paper

In brief

“Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys” is a 2018 journal article by Uwe Arlic and 3 co-authors, published in Materials Research. OpenAlex counts 14 citations as of 22 November 2026. It is open access under a CC BY licence: the full text is free to read at Materials Research.

Citations
14
Most cited in
2021 (4)
Field-weighted impact
0.40
References
27
Authors
4

Abstract

Alloys of CuAlMn are known as cheap, high strength shape memory alloys with an excellent damping capacity within their austenitic-martensitic phase transformation, compared to alloy systems like NiTi, CuZnAl or MnCu. But CuAlMn alloys have disadvantage due to generation of voids by a high shrinkage which further increases the existing proneness to stress cracks during rapid cooling. Alloying grain refining elements improves the stress crack resistance and enables a wide range of rapid quenching parameters which are needed to control the temperature of martensitic phase transformation. Additionally, the elements itself influence the in- or decreasing of the phase transformation temperature and the SMA effects. Furthermore, some of these elements can reduce the internal friction indirectly by decomposing areas of metastable martensite into its stabilized forms, where no transformation occurs. This thermic stability can be calculated by the concentration of valence electrons in a unit cell. The proneness to ageing is controlled by multistep heat treatments. Annealing and rapid quenching into the area of martensitic phase transformation maximize the generation of point defects. A high amount of point defects contradicts the negative effect of pinning. It also preserves the material from extreme brittleness. The influences of these effects are shown at single cantilever bending beams by elastic strain amplitude (ε = 12E-4) depending measurements of internal friction at natural frequency along the ageing at room temperature (293 K) up to 2500 h. The samples are annealed at 1123 K for 15 min (CuAl14Mn2) and 1100K for 30min (CuAl11Mn5) afterwards rapid quenched to 370 K with no further thermic stabilisation. The base alloy of CuAl14.1Mn2.0Ni1.9Fe0.4 had an internal friction measured as logarithmic Decrement (δ) of 0.155 and 0.11 after 2500 h of ageing at RT. The phase transformation is located between 284 K and 352 K, measured by DSC. The alloy of CuAl11.1Mn5.5Zn2.9Ni2.1 had a logarithmic decrement of 0.31 and diminish continuously to 0.12 after 2500 h of ageing at RT. The phase transformation is located between 287 K and 318 K.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Arlic, U., Zak, H., Weidenfeller, B., & Riehemann, W. (2018). Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys. Materials Research, 21(suppl 2). https://doi.org/10.1590/1980-5373-mr-2017-0897

MLA 9

Arlic, Uwe, et al. “Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys.” Materials Research, vol. 21, no. suppl 2, 2018. https://doi.org/10.1590/1980-5373-mr-2017-0897.

Chicago

Arlic, Uwe, Hennadiy Zak, B. Weidenfeller, and Werner Riehemann. 2018. “Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys.” Materials Research 21 (suppl 2). https://doi.org/10.1590/1980-5373-mr-2017-0897.

Harvard

Arlic, U. et al. (2018) ‘Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys’, Materials Research, 21(suppl 2). doi:10.1590/1980-5373-mr-2017-0897.

IEEE

U. Arlic, H. Zak, B. Weidenfeller, and W. Riehemann, “Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys,” Materials Research, vol. 21, no. suppl 2, 2018, doi: 10.1590/1980-5373-mr-2017-0897.

BibTeX

@article{arlic2018impact,
  title     = {{Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys}},
  author    = {Arlic, Uwe and Zak, Hennadiy and Weidenfeller, B. and Riehemann, Werner},
  journal   = {Materials Research},
  year      = {2018},
  volume    = {21},
  number    = {suppl 2},
  doi       = {10.1590/1980-5373-mr-2017-0897},
  url       = {https://doi.org/10.1590/1980-5373-mr-2017-0897}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
202011
202144
202244
202322
202633

Its field-weighted citation impact is 0.40: it has been cited 0.40 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Materials Science › Materials Chemistry › Shape Memory Alloy Transformations

  • martensitic transformation
  • thermal stabilization
  • alloying elements
  • grain refinement
  • stress cracking
  • rapid quenching
  • aging materials
  • internal friction

Work with this paper

Most-cited papers in Materials Science

All highly cited Materials Science papers

Questions about this paper

How do I cite this paper in APA style?

Arlic, U., Zak, H., Weidenfeller, B., & Riehemann, W. (2018). Impact of Alloy Composition and Thermal Stabilization on Martensitic Phase Transformation Structures in CuAlMn Shape Memory Alloys. Materials Research, 21(suppl 2). https://doi.org/10.1590/1980-5373-mr-2017-0897

How many times has this paper been cited?

14 times, according to OpenAlex on 22 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Materials Research: sign in and open the PDF from this page.

Who wrote this paper?

Uwe Arlic, Hennadiy Zak, B. Weidenfeller, Werner Riehemann.

What is the DOI of this paper?

10.1590/1980-5373-mr-2017-0897, permanently at https://doi.org/10.1590/1980-5373-mr-2017-0897. Sign in and open it from this page.

Bibliographic data from OpenAlex (CC0), last checked 22 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.