Dissertation · 2010 · Open access
Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition
Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia) · Published 1 June 2010
In brief
“Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition” is a 2010 dissertation by Setareh Monshi Toussi, published in Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia). OpenAlex counts 0 citations as of 16 November 2026. It is open access: the full text is free to read at Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia).
- Citations
- 0
- Authors
- 1
Abstract
Research on the area of the synthesis of carbon nanotubes is fundamental and critical to the entire subject of carbon nanotubes. This dissertation describes an experiment to synthesize carbon nanotubes by the method of catalytic chemical vapor deposition (CCVD). It focuses on the relationship between the as-prepared catalyst and the synthesized carbon nanotubes. The effect of growth parameters for the synthesis of carbon nanotubes was also studied. The Fe-Mo-MgO catalysts with five different molar ratios of iron (Fe) in this composite catalyst were prepared through the impregnation method. The goal of this work was to identify the suitable molar ratio of iron (Fe) in the composite catalyst of Fe-Mo-MgO on which carbon nanotubes (CNTs) can be grown with a higher yield and quality.Scanning electron microscopy (SEM), transmission electron microscopy (TEM), xray diffraction (XRD), and thermogravimetric analysis (TGA) were used to characterize the as-prepared catalysts and as-grown carbon nanotube samples. Among these catalysts with different molar ratio of iron, the main and obvious observation in the synthesis of carbon nanotubes was the yield of synthesized carbon nanotubes. That is, increasing the molar ratio of iron, the yield of produced carbon nanotubes increases strongly, but the quality did not improve. While by decreasing the Fe concentration, both the structural defects and yield were reduced. Therefore, based on the experimental results, the best catalyst was catalyst 3 (Fe: Mo: MgO = 0.5: 0.1: 10) with a moderate molar ratio of iron. This catalyst not only had good yield but also good quality. The different parameters such as flow rate of argon (Ar) as a carrier gas, and temperature to improve the growth condition of CCVD method for the synthesis of CNTs by Fe-Mo-MgO catalyst were examined. It is found that the best flow rate for carrier gas is 100 ml/min. For the flow rate lower or higher than this, there were very few CNTs formed, since the low flow rate of Ar could not carry enough ethanol vapors through the reactor to be deposited on the catalyst. As for the high flow rate of Ar, most of the carbon source exited from the outlet of the reactor and again they could not be deposited on the catalyst, thus few carbon nanotubes were formed. In the synthesis of carbon nanotubes by CCVD method, the temperature plays a key role. The results show that when the temperature is lower than 750°C, few CNTs were formed, and when the temperature is higher than 900°C, more and more amorphous carbons were formed in the CNTs. The best…
Cite this paper
Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.
APA 7
Toussi, S. M. (2010). Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition. Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia). http://psasir.upm.edu.my/id/eprint/12449/1/ITMA_2010_2A.pdf
MLA 9
Toussi, Setareh Monshi. “Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition.” Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia), 2010. http://psasir.upm.edu.my/id/eprint/12449/1/ITMA_2010_2A.pdf.
Chicago
Toussi, Setareh Monshi. 2010. “Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition.” Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia). http://psasir.upm.edu.my/id/eprint/12449/1/ITMA_2010_2A.pdf.
Harvard
Toussi, S. M. (2010) ‘Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition’, Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia). Available at: http://psasir.upm.edu.my/id/eprint/12449/1/ITMA_2010_2A.pdf.
IEEE
S. M. Toussi, “Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition,” Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia), 2010.
BibTeX
@phdthesis{toussi2010effects,
title = {{Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition}},
author = {Toussi, Setareh Monshi},
year = {2010},
url = {http://psasir.upm.edu.my/id/eprint/12449/1/ITMA_2010_2A.pdf}
}
Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)
Topic and keywords
Physical Sciences › Materials Science › Materials Chemistry › Carbon Nanotubes in Composites
- carbon nanotubes
- catalytic chemical vapor deposition
- catalyst composition
- ethanol precursor
- growth temperature
- structural defects
- impregnation method
- composite catalysts
Work with this paper
Most-cited papers in Materials Science
- Electric Field Effect in Atomically Thin Carbon FilmsKostya S. Novoselov, Andre K. Geim, Sergey V. Morozov and 5 more · Science · 2004 · 67,474 citations
- Revised effective ionic radii and systematic studies of interatomic distances in halides and chalcogenidesROBERT D. SHANNON · Acta Crystallographica Section A · 1976 · 66,944 citations
- Ab initio molecular dynamics for liquid metalsGeorg Kresse, J. Häfner · Physical review. B, Condensed matter · 1993 · 46,320 citations
- Helical microtubules of graphitic carbonSumio Iijima · Nature · 1991 · 43,639 citations
- The rise of grapheneAndre K. Geim, Kostya S. Novoselov · Nature Materials · 2007 · 40,328 citations
Questions about this paper
How do I cite this paper in APA style?
Toussi, S. M. (2010). Effects Of Molar Ratio Of Iron Catalyst On Synthesis Of Carbon Nanotubes Via Catalytic Chemical Vapor Deposition. Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia). http://psasir.upm.edu.my/id/eprint/12449/1/ITMA_2010_2A.pdf
How many times has this paper been cited?
0 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.
Is this paper free to read?
Yes. It is open access: read the free full text at Universiti Putra Malaysia Institutional Repository (Universiti Putra Malaysia).
Who wrote this paper?
Setareh Monshi Toussi.
Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.