Paper · 2018 · Open access

Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication

Yosef Jazaa

Iowa State University Digital Repository (Iowa State University) · Published 1 January 2018

Open PDFCite this paper

In brief

“Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication” is a 2018 paper by Yosef Jazaa, published in Iowa State University Digital Repository (Iowa State University). OpenAlex counts 8 citations as of 17 November 2026, which puts it in the top 7% of works published in 2018 by citations. It is open access: the full text is free to read at Iowa State University Digital Repository (Iowa State University).

Citations
8
Most cited in
2022 (3)
Field-weighted impact
0.32
References
100
Authors
1

Abstract

In this study, three different nanoparticles (CuO, WC, WS2) of comparable nominal diameter, were added to a Polyalphaolefin (PAO) base oil to evaluate tribological response in the boundary lubrication regime. The concentration of particles was fixed at 1% by weight for this study and different surfactants (Oleic acid, polyisobutylene succinimide) and dispersion methods were employed to determine the impact on agglomeration and the observed tribological response. The results showed that of the methods studied, adding 10 % Oleic acid (OA) while sonicating the particles for 30 minutes reduced the agglomeration the most and adding 1% Oleic acid while sonicating the particles for 120 minutes produced a more uniform dispersion. Furthermore, this study investigates the effect of the surface treatment of MoS2 and WS2 on their tribological behavior in boundary lubricant regime The nanoparticles were dispersed in Polyalphaolefin (PAO) using the following techniques: 1) 60 minutes sonication without using a stabilizing agent, 2) 60 minutes sonication with 1% of weight Oleic acid (OA), and 3) functionalizing the nanoparticles using polyvinylpyrrolidone. The size distribution of the dispersed nanoparticles in PAO was measured by dynamic light scattering. The nanoparticles functionalized using Polyvinylpyrrolidone resulted in the most stable particles size and homogeneous mixture dispersion. Friction studies show that the introduction of nanoparticles additives does not appreciably impact the friction of the interface for most cases in comparison to the base oil. Reciprocating wear experiments showed that the addition of nanoparticles without surfactants did not significantly increase the wear resistance compared to the base oil. Finally, this study investigates the dispersion techniques for CuO and WC nanoadditives on their effect on the rolling contact fatigue, using the best oil formulation that provided a stable suspension and agglomeration reduction for both materials. Tungsten carbide nanofluids showed the best micropitting resistantance behavior followed by copper oxide nanofluids under the boundary lubrication regime. Agglomeration reduction and homogeneous particles dispersion contribute to the wear reduction. The results of the friction and wear studies contributes to a better understanding of the tribological mechanism of the nanoadditives in base oil and clarify the difference between reducing agglomeration and improving dispersion. In this study, it is hypothesized that the additives might deposit on the surface and forming a physical tribofilm. In addition, if the nanoparticles fill the gaps between the surface roughness asperities which increase the true contact area, the particles can assist in movement like a nanoscale ball bearing. Depending upon the nanoparticles used, of evidence both mechanisms were found.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Jazaa, Y. (2018). Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication. Iowa State University Digital Repository (Iowa State University). https://lib.dr.iastate.edu/cgi/viewcontent.cgi?article=7780&context=etd

MLA 9

Jazaa, Yosef. “Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication.” Iowa State University Digital Repository (Iowa State University), 2018. https://lib.dr.iastate.edu/cgi/viewcontent.cgi?article=7780&context=etd.

Chicago

Jazaa, Yosef. 2018. “Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication.” Iowa State University Digital Repository (Iowa State University). https://lib.dr.iastate.edu/cgi/viewcontent.cgi?article=7780&context=etd.

Harvard

Jazaa, Y. (2018) ‘Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication’, Iowa State University Digital Repository (Iowa State University). Available at: https://lib.dr.iastate.edu/cgi/viewcontent.cgi?article=7780&context=etd.

IEEE

Y. Jazaa, “Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication,” Iowa State University Digital Repository (Iowa State University), 2018.

BibTeX

@article{jazaa2018effect,
  title     = {{Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication}},
  author    = {Jazaa, Yosef},
  journal   = {Iowa State University Digital Repository (Iowa State University)},
  year      = {2018},
  url       = {https://lib.dr.iastate.edu/cgi/viewcontent.cgi?article=7780&context=etd}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
202122
202233
202322
202611

Its field-weighted citation impact is 0.32: it has been cited 0.32 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Engineering › Mechanical Engineering › Lubricants and Their Additives

  • nanoparticle lubricant additives
  • boundary lubrication
  • polyalphaolefin
  • copper oxide nanoparticles
  • tungsten carbide nanoparticles
  • MoS2 nanoparticles
  • WS2 nanoparticles
  • oleic acid surfactant

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Jazaa, Y. (2018). Effect of nanoparticle additives on the tribological behavior of oil under boundary lubrication. Iowa State University Digital Repository (Iowa State University). https://lib.dr.iastate.edu/cgi/viewcontent.cgi?article=7780&context=etd

How many times has this paper been cited?

8 times, according to OpenAlex on 17 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Iowa State University Digital Repository (Iowa State University): sign in and open the PDF from this page.

Who wrote this paper?

Yosef Jazaa.

Bibliographic data from OpenAlex (CC0), last checked 17 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.