Paper · 2020 · Open access

Detection of rate change of induced seismicity using ETAS model

Hideo Aochi, Julie Maury, Thomas Le Guénan

HAL · Published 29 October 2020

Open full textCite this paper

In brief

“Detection of rate change of induced seismicity using ETAS model” is a 2020 paper by Hideo Aochi and 2 co-authors, published in HAL. OpenAlex counts 0 citations as of 21 November 2026. It is open access: the full text is free to read at HAL.

Citations
0
Authors
3

Abstract

ETAS (Epidemic-Type Aftershock Sequence) model (e.g. Ogata, 1983, 1988) is widely used for natural seismicity, mostly supporting the stationarity of the background seismicity rate caused by tectonics. On the other hand, induced seismicity rate evolves with ongoing operation (fluid injection, etc.) and the assessment of non-stationary seismicity is important. In this study, we apply the ETAS model to detect the seismicity change and aim to characterize the obtained ETAS parameters with the operation information such as injected fluid volume. A standard, stationary ETAS model consists of five parameters (μ, K, α, c, p). The first parameter μ (number of earthquakes par day) is usually considered stationary. The other four concern the cumulative effect of the triggered events. The ratio between μand K tells that the importance of the "induced" events with respect to "triggered" ones in a sequence. However no explicit formulation of variable μis known for non-stationary seismicity. Therefore, we are going to decluster the observed seismicity into μ (hereafter called "declustered seismicity rate") and the triggered part. We have applied ETAS model on different data sets: 2000 Soultz-sous-Forêt, France (stimulation test at deep geothermal site), 2010-2013 Rousse, France (CO 2 storage experiment in depleted gas reservoir) and 2010-2018 Oklahoma, USA (waste water injection, principally). In particular, the seismicity in Oklahoma expands in space and time due to massive injection from multiple wells. We carry out a systematic regression on Oklahoma data (Oklahoma Geological Survey). Spatially, we select each area with a radius of 20 km to have a sufficient number of earthquakes. Temporally, we fix a time window of 200 events, shifting by 50 events, such that the regression is stable enough. After some trials, we determine two variables of interest (μ, K) by fixing the three other parameters. Figure 1 shows the regression result on the declustered seismicity rate μand the total injected volume on the same area based on the data reported by Oklahoma Corporation Commission, Oil and Gas Division. The variable K does not change significantly. In Figure 1, total volume injected in Arbuckle layers is calculated for each area, and μis calculated at the 53 areas where there are more than 250 earthquakes recorded of magnitude larger than and equal to 2.3 between 2010 and 2018. The peaks of μappears from the end of 2014 to 2015. We find that the appearance of high μdoes not always corresponds to the high injected volume area We then analyze among the parameters. The acceleration of μcan be fitted through an exponential function of normalized total injected…

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Aochi, H., Maury, J., & Le Guénan, T. (2020). Detection of rate change of induced seismicity using ETAS model. HAL. https://brgm.hal.science/hal-02917911

MLA 9

Aochi, Hideo, et al. “Detection of rate change of induced seismicity using ETAS model.” HAL, 2020. https://brgm.hal.science/hal-02917911.

Chicago

Aochi, Hideo, Julie Maury, and Thomas Le Guénan. 2020. “Detection of rate change of induced seismicity using ETAS model.” HAL. https://brgm.hal.science/hal-02917911.

Harvard

Aochi, H., Maury, J. and Le Guénan, T. (2020) ‘Detection of rate change of induced seismicity using ETAS model’, HAL. Available at: https://brgm.hal.science/hal-02917911.

IEEE

H. Aochi, J. Maury, and T. Le Guénan, “Detection of rate change of induced seismicity using ETAS model,” HAL, 2020.

BibTeX

@article{aochi2020detection,
  title     = {{Detection of rate change of induced seismicity using ETAS model}},
  author    = {Aochi, Hideo and Maury, Julie and Le Guénan, Thomas},
  journal   = {HAL},
  year      = {2020},
  url       = {https://brgm.hal.science/hal-02917911}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Energy › Fuel Technology › Hydraulic Fracturing and Reservoir Analysis

  • induced seismicity
  • ETAS model
  • background seismicity rate
  • fluid injection
  • wastewater injection
  • CO2 sequestration
  • geothermal stimulation
  • Oklahoma seismicity

Work with this paper

Most-cited papers in Energy

All highly cited Energy papers

Questions about this paper

How do I cite this paper in APA style?

Aochi, H., Maury, J., & Le Guénan, T. (2020). Detection of rate change of induced seismicity using ETAS model. HAL. https://brgm.hal.science/hal-02917911

How many times has this paper been cited?

0 times, according to OpenAlex on 21 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at HAL: sign in and open the full text from this page.

Who wrote this paper?

Hideo Aochi, Julie Maury, Thomas Le Guénan.

Bibliographic data from OpenAlex (CC0), last checked 21 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.