Journal article · 2026 · Open access

Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace

Christian Kislinger, Georg Daurer, Gabriel Manier, Jean-Charles Boullot, Stefan Schwarz, Martin Demuth, Christian Gaber, Christoph Hochenauer

Applied Thermal Engineering, 291, 130276 · Published 13 February 2026 · DOI 10.1016/j.applthermaleng.2026.130276

Open full textCite this paper

In brief

“Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace” is a 2026 journal article by Christian Kislinger and 7 co-authors, published in Applied Thermal Engineering. OpenAlex counts 6 citations as of 22 November 2026, which puts it in the top 3% of works published in 2026 by citations. It is open access under a CC BY licence: the full text is free to read at Applied Thermal Engineering.

Citations
6
Most cited in
2026 (6)
Field-weighted impact
9.12
References
46
Authors
8

Abstract

Industrial reheating furnaces face increasing demands for higher efficiency and lower emissions, yet the impact of oxygen-enriched and oxy-fuel combustion on furnace performance is still insufficiently understood on an operational scale. Previous studies often applied fixed burner power distributions across oxidizer conditions, which neglected zone-specific heating requirements and led to deviations from the intended thermal heating behavior of the products. To address this gap, a thermodynamic redistribution method was developed to adjust the zonal fuel input to the oxidizers studied while maintaining the original furnace characteristics and heating curves of the products. A numerically inexpensive three-dimensional RANS model was then coupled with a transient bloom model, enabling consistent representation of both furnace flow and bloom heating and confirming the method. The procedure was validated against detailed furnace measurements, including bloom heating curves, furnace temperature, flue gas compositions, NO x emissions, and wall temperatures. Results showed that enrichment to 25 vol% O 2 reduced fuel demand and CO 2 emissions by 4.8%, but more than doubled NO formation, whereas partial substitution with oxy-fuel in one combustion zone offered comparable savings while keeping NO x emissions low. Radiation remained the dominant heat transfer mechanism, and overall temperature fields were largely unaffected. Comparison with CFD confirmed that the developed thermodynamic approach reproduces global power balances reliably, demonstrating its robustness and applicability to a wide range of oxidizer–fuel configurations in industrial furnaces. To incorporate the different combustion modes consistently, combustion-dependent coefficients were introduced for the gas absorption coefficient calculation, while burner-type-dependent values were applied for the turbulent Schmidt and Prandtl numbers.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Kislinger, C., Daurer, G., Manier, G., Boullot, J.-C., Schwarz, S., Demuth, M., Gaber, C., & Hochenauer, C. (2026). Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace. Applied Thermal Engineering, 291, 130276. https://doi.org/10.1016/j.applthermaleng.2026.130276

MLA 9

Kislinger, Christian, et al. “Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace.” Applied Thermal Engineering, vol. 291, 2026, p. 130276. https://doi.org/10.1016/j.applthermaleng.2026.130276.

Chicago

Kislinger, Christian, Georg Daurer, Gabriel Manier, Jean-Charles Boullot, Stefan Schwarz, Martin Demuth, Christian Gaber, and Christoph Hochenauer. 2026. “Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace.” Applied Thermal Engineering 291: 130276. https://doi.org/10.1016/j.applthermaleng.2026.130276.

Harvard

Kislinger, C. et al. (2026) ‘Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace’, Applied Thermal Engineering, 291, p. 130276. doi:10.1016/j.applthermaleng.2026.130276.

IEEE

C. Kislinger et al., “Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace,” Applied Thermal Engineering, vol. 291, p. 130276, 2026, doi: 10.1016/j.applthermaleng.2026.130276.

BibTeX

@article{kislinger2026detailed,
  title     = {{Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace}},
  author    = {Kislinger, Christian and Daurer, Georg and Manier, Gabriel and Boullot, Jean-Charles and Schwarz, Stefan and Demuth, Martin and Gaber, Christian and Hochenauer, Christoph},
  journal   = {Applied Thermal Engineering},
  year      = {2026},
  volume    = {291},
  pages     = {130276},
  doi       = {10.1016/j.applthermaleng.2026.130276},
  url       = {https://doi.org/10.1016/j.applthermaleng.2026.130276}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Computational Mechanics › Combustion and flame dynamics

  • reheating furnace
  • oxygen-enriched combustion
  • fuel consumption reduction
  • NOx emissions
  • radiation heat transfer
  • CO2 emissions

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Kislinger, C., Daurer, G., Manier, G., Boullot, J.-C., Schwarz, S., Demuth, M., Gaber, C., & Hochenauer, C. (2026). Detailed CFD study of air–fuel, oxygen-enriched and partial oxy-fuel combustion with optimized fuel savings in an industrial reheating furnace. Applied Thermal Engineering, 291, 130276. https://doi.org/10.1016/j.applthermaleng.2026.130276

How many times has this paper been cited?

6 times, according to OpenAlex on 22 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access at Applied Thermal Engineering: sign in and open the full text from this page.

Who wrote this paper?

Christian Kislinger, Georg Daurer, Gabriel Manier, Jean-Charles Boullot, Stefan Schwarz, Martin Demuth, Christian Gaber, Christoph Hochenauer.

What is the DOI of this paper?

10.1016/j.applthermaleng.2026.130276, permanently at https://doi.org/10.1016/j.applthermaleng.2026.130276. Sign in and open it from this page.

Bibliographic data from OpenAlex (CC0), last checked 22 November 2026. ResearchGuru does not host this paper; once you are signed in, the links open it at the publisher or the repository that does.