Journal article · 2005 · Open access

Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance

Stefan Klein, F. Finger, Reinhard Carius, M. Stutzmann

Journal of Applied Physics, 98(2) · Published 15 July 2005 · DOI 10.1063/1.1957128

Read the free full textView at the publisherCite this paper

In brief

“Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance” is a 2005 journal article by Stefan Klein and 3 co-authors, published in Journal of Applied Physics. OpenAlex counts 105 citations as of 16 November 2026. It is open access: the full text is free to read at JuSER (Forschungszentrum Jülich).

Citations
105
Most cited in
2013 (8)
Field-weighted impact
10.60
References
69
Authors
4

Abstract

Microcrystalline silicon (μc-Si:H) of superior quality can be prepared using the hot-wire chemical-vapor deposition method (HWCVD). At a low substrate temperature (TS) of 185 °C excellent material properties and solar cell performance were obtained with spin densities of 6×1015cm−3 and solar cell efficiencies up to 9.4%, respectively. In this study we have systematically investigated the influence of various deposition parameters on the deposition rate and the material properties. For this purpose, thin films and solar cells were prepared at specific substrate and filament temperatures and deposition pressures (pD), covering the complete range from amorphous to highly crystalline material by adjusting the silane concentration. The influence of these deposition parameters on the chemical reactions at the filament and in the gas phase qualitatively explains the behavior of the structural composition and the formation of defects. In particular, we propose that the deposition rate is determined by the production of reactive species at the filament and a particular atomic-hydrogen-to-silicon ratio is found at the microcrystalline/amorphous transition. The structural, optical, and electronic properties were studied using Raman and infrared spectroscopies, optical-absorption measurements, electron-spin resonance, and dark and photoconductivities. These experiments show that higher TS and pD lead to a deterioration of the material quality, i.e., much higher defect densities, oxygen contaminations, and SiH absorption at 2100cm−1. Similar to plasma enhanced chemical-vapor deposition material, μc-Si:H solar cells prepared with HW i layers show increasing open circuit voltages (Voc) with increasing silane concentration and best performance is achieved near the transition to amorphous growth. Such solar cells prepared at low TS exhibit very high Voc up to 600 mV and fill factors above 70% with i layers prepared by HWCVD.

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Klein, S., Finger, F., Carius, R., & Stutzmann, M. (2005). Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance. Journal of Applied Physics, 98(2). https://doi.org/10.1063/1.1957128

MLA 9

Klein, Stefan, et al. “Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance.” Journal of Applied Physics, vol. 98, no. 2, 2005. https://doi.org/10.1063/1.1957128.

Chicago

Klein, Stefan, F. Finger, Reinhard Carius, and M. Stutzmann. 2005. “Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance.” Journal of Applied Physics 98 (2). https://doi.org/10.1063/1.1957128.

Harvard

Klein, S. et al. (2005) ‘Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance’, Journal of Applied Physics, 98(2). doi:10.1063/1.1957128.

IEEE

S. Klein, F. Finger, R. Carius, and M. Stutzmann, “Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance,” Journal of Applied Physics, vol. 98, no. 2, 2005, doi: 10.1063/1.1957128.

BibTeX

@article{klein2005deposition,
  title     = {{Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance}},
  author    = {Klein, Stefan and Finger, F. and Carius, Reinhard and Stutzmann, M.},
  journal   = {Journal of Applied Physics},
  year      = {2005},
  volume    = {98},
  number    = {2},
  doi       = {10.1063/1.1957128},
  url       = {https://doi.org/10.1063/1.1957128}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Citations by year

YearCitationsShare of the best year
201388
201477
201544
201644
201722
201811
201922
202022
202422
202511

Its field-weighted citation impact is 10.60: it has been cited 10.60 times as often as the average work of the same field, type and year (1.00 is the world average).

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon and Solar Cell Technologies

  • microcrystalline silicon
  • hydrogenated amorphous silicon
  • hot filament chemical vapor deposition
  • thin-film solar cells
  • deposition parameters
  • substrate temperature
  • deposition pressure
  • silane concentration

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Klein, S., Finger, F., Carius, R., & Stutzmann, M. (2005). Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: The influence of the deposition parameters on the material properties and solar cell performance. Journal of Applied Physics, 98(2). https://doi.org/10.1063/1.1957128

How many times has this paper been cited?

105 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at JuSER (Forschungszentrum Jülich).

Who wrote this paper?

Stefan Klein, F. Finger, Reinhard Carius, M. Stutzmann.

What is the DOI of this paper?

10.1063/1.1957128. The permanent link is https://doi.org/10.1063/1.1957128.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.