Paper · 2015 · Open access

Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells

Mathieu Boccard, Zachary Charles Holman

OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) · Published 6 April 2015

Read the free full textCite this paper

In brief

“Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells” is a 2015 paper by Mathieu Boccard and Zachary Charles Holman, published in OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information). OpenAlex counts 0 citations as of 16 November 2026. It is open access: the full text is free to read at OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information).

Citations
0
Authors
2

Abstract

"Very efficient crystalline silicon (c-Si) solar cells have been demonstrated when thin layers of intrinsic and doped hydrogenated amorphous silicon (a-Si:H) are used for passivation and carrier selectivity in a heterojunction device. One limitation of this device structure is the (parasitic) absorption in the front passivation/collection a-Si:H layers; another is the degradation of the a-Si:H-based passivation upon temperature, limiting the post-processes to approximately 200°C thus restricting the contacting possibilities and potential tandem device fabrication. To alleviate these two limitations, we explore the potential of amorphous silicon carbide (a-SiC:H), a widely studied material in use in standard a-Si:H thin-film solar cells, which is known for its wider bandgap, increased hydrogen content and stronger hydrogen bonding compared to a-Si:H. We study the surface passivation of solar-grade textured n-type c-Si wafers for symmetrical stacks of 10-nm-thick intrinsic a-SiC:H with various carbon content followed by either p-doped or n-doped a-Si:H (referred to as i/p or i/n stacks). For both doping types, passivation (assessed through carrier lifetime measurements) is degraded by increasing the carbon content in the intrinsic a-SiC:H layer. Yet, this hierarchy is reversed after annealing at 350°C or more due to drastic passivation improvements upon annealing when an a-SiC:H layer is used. After annealing at 350°C, lifetimes of 0.4 ms and 2.0 ms are reported for i/p and i/n stacks, respectively, when using an intrinsic a-SiC:H layer with approximately 10% of carbon (initial lifetimes of 0.3 ms and 0.1 ms, respectively, corresponding to a 30% and 20-fold increase, respectively). For stacks of pure a-Si:H material the lifetimes degrade from 1.2 ms and 2.0 ms for i/p and i/n stacks, respectively, to less than 0.1 ms and 1.1 ms (12-fold and 2-fold decrease, respectively). For complete solar cells using pure a-Si:H i/p and i/n stacks, the open-circuit voltage (Voc) drops from 720 mV to 600 mV when annealing the device at 350°C. Yet, the Voc of devices using an intrinsic a-SiC:H layer with around 10% carbon content in the i/p stack is more resilient to such process, dropping from 710 mV to 690 mV. Also, irrespective of annealing, the slightly improved transparency of a-SiC:H layers allows about 1% current gain due to a better blue-light response. Active-area efficiencies above 20% are thus obtained for particular carbon content conditions, slightly higher than for devices using only a-Si:H. Even for a-SiC:H layers with bandgaps of up to 2.1 eV, good hole collection is maintained (with fill factors of 67% for devices using intrinsic a-SiC:H in the i/p stack, compared to 73% for the reference device). However…

Cite this paper

Formatted from the catalogue record. Check names, capitals and page numbers against the paper before you submit.

APA 7

Boccard, M., & Holman, Z. C. (2015). Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells. OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information). https://www.osti.gov/servlets/purl/1229761

MLA 9

Boccard, Mathieu, and Zachary Charles Holman. “Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells.” OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information), 2015. https://www.osti.gov/servlets/purl/1229761.

Chicago

Boccard, Mathieu and Zachary Charles Holman. 2015. “Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells.” OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information). https://www.osti.gov/servlets/purl/1229761.

Harvard

Boccard, M. and Holman, Z. C. (2015) ‘Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells’, OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information). Available at: https://www.osti.gov/servlets/purl/1229761.

IEEE

M. Boccard and Z. C. Holman, “Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells,” OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information), 2015.

BibTeX

@article{boccard2015amorphous,
  title     = {{Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells}},
  author    = {Boccard, Mathieu and Holman, Zachary Charles},
  journal   = {OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information)},
  year      = {2015},
  url       = {https://www.osti.gov/servlets/purl/1229761}
}

Download for a reference manager: BibTeX (.bib) · RIS for Zotero, Mendeley and EndNote (.ris)

Topic and keywords

Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon and Solar Cell Technologies

  • amorphous silicon carbide
  • hydrogenated amorphous silicon
  • surface passivation
  • carrier lifetime
  • high-temperature annealing
  • carbon content
  • parasitic absorption
  • open-circuit voltage

Work with this paper

Most-cited papers in Engineering

All highly cited Engineering papers

Questions about this paper

How do I cite this paper in APA style?

Boccard, M., & Holman, Z. C. (2015). Amorphous Silicon Carbide Passivating Layers to Enable Higher Processing Temperature in Crystalline Silicon Heterojunction Solar Cells. OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information). https://www.osti.gov/servlets/purl/1229761

How many times has this paper been cited?

0 times, according to OpenAlex on 16 November 2026. Google Scholar and Scopus count different sets of sources, so their numbers differ.

Is this paper free to read?

Yes. It is open access: read the free full text at OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information).

Who wrote this paper?

Mathieu Boccard, Zachary Charles Holman.

Bibliographic data from OpenAlex (CC0), last checked 16 November 2026. ResearchGuru does not host this paper; the links go to the publisher or the repository that does.